BLOTZ B10-MW-108 User manual

10mm 3x2 Shops Foyer
B10-MW-108
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Foyer (B10-MW-108)
Start by removing the long sides from the sprue
along with 2 of the corner bracers per side.
Glue the bracers into position (as shown above) and
glue one short side into place. Allow to dry.
Once dry attach the sides together to form an
open box.
Glue the columns and balconies into position on each
of the long sides.
Then repeat this for the two short sides.

10mm 3x2 Shops Middle
B10-MW-154
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Mid-Section (B10-MW-154)
Remove the four walls and four triangular corner
bracers from the sprue. Glue the triangles to
non-etched side of the two long walls as shown
in the example above. Also attach the support to
the bottom edge of the long wall. Leave to dry.
Once the bracers are dry apply a little glue to the side
lugs and glue the shorter walls in place as shown
above. You should now have a hollow square
structure. Leave it to dry.
Note: In the image above the structure is upside
down so the supports are seen at the top of the
picture.
Glue the balconies into position on the long
walls…
…and then on the short walls.

10mm 3x2 Shops oof
B10-MW-204
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
oof Section (B10-MW-204)
Remove the four walls roof and supports from
the sprue.
Glue the balconies into position below the
windows.
Apply glue to the edges of the roof and attach the
walls to it using the lugs provided (etched detail
outwards).
Glue the balconies into position below the
windows on the long sides…
..then on the short sides.