BLOTZ B20-ME-002 User manual

20mm Middle Eastern Building #2
B20-ME-002
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the two main walls and the front wall for the
larger structure from the sprue.
Fasten then together in an “H” shape as shown and
glue them to the base using the guidelines to help
position them.
Take the centre and rear walls of the main building.. .. and glue them into position.
Remove the final three walls Attach these to form the smaller structure.
Remove the two doors and the roof supports. The smaller structure uses the two short roof supports
and two of the longer supports. Also attach the
supports inside the main structure.

Glue the trapdoors to the roof sections and place (do
not glue) them on top of the roof supports.
Glue the gateway piece into place.
The finished building