Blue Ridge 21TAA-4 User manual

INSTALL GUIDE
FOR: TOYOTA TACOMA ATTIC (CREW CAB ONLY)
WILL NOT FIT ACCESS CAB
TOOLS YOU NEED: NEEDLE NOSE PLIERS
STEP #1
STEP #2
STEP #3
Welcome! This installation isn’t rocket science but it is kind of like karate - you can hurt yourself or break
something if you don’t pay attention. Used properly, this Install Guide will tell you all you need to know
- like Yoda, but with better grammar.
If you have any trouble, contact us for product support: blueridgeoverlandgear.com/pages/contact-us
Locate the 2 hanger hooks on the rear ceiling
of the cab and remove the covers by pulling.
Please Note: This product is for 4th generation
Toyota Tacoma’s and after (crew cab only)
Using the needle nose pliers, pinch the metal
clasp inside the hanger hooks. Remove the
hanger hook and also the metal clasp.
Re-insert the metal clasp into the hanger
hooks. Take the included Rear Anchor Tabs
and place them onto the hanger tabs with the
metal clasp through the hole in the fabric.
p.1 GO TO NEXT PAGE >
1
2
3

INSTALL GUIDE: TACOMA ATTIC
continued
p.2
Thank you for choosing Blue Ridge Overland Gear. We are handcrafting the toughest bags and
organizers for your adventurous life - right here in Bedford, Virginia, USA. It’s not just American made,
it’s ‘Blue Ridge Built’!
This product comes with our Rugged Lifetime Warranty. If you have any trouble, contact us for
product support: BlueRidgeOverlandGear.com/pages/contact-us
VISIT US AT: BLUERIDGEOVERLANDGEAR.COM
STEP #4
STEP #5
STEP #7
STEP #6
Clip the attic to the buckles on the 2 Rear
Anchor Tabs. NOTICE: Make sure that the attic
is oriented so that the paracord is facing down.
Pull the tails on the front straps out and away
from the attic to achieve desired tension.
Tighten the paracord by grasping the barrel
lock with one hand and pull the end with the
other to achieve desired tension.
NOTE: Make sure not to overload the attic - and use it to
store softer lightweight items. Enjoy!
Pass the 2 front straps on the attic over the
grab handles and attach the G-Hooks of the
attic back to the flat loops along the front edge
of the attic.
WARNING: Do NOT attach the G-Hooks to the strap.
They must be attached to the loops on the attic.
Take the Rear Anchor Tabs assembly from
Step #3 and press the hooks back into the
holes until you hear the click. Push the covers
back onto both hooks.
123