bluu 120 GALLON DECK BOX User manual

®
120 GALLON
DECK BOX
ASSEMBLY INSTRUCTIONS
IMPORTANT:
• READ CAREFULLY AND KEEP FOR FUTURE REFERENCE.
• PLEASE CONTACT CUSTOMER SERVICE IF YOU HAVE ANY PROBLEMS OR DISCOVER ANY MISSING PARTS.
CARE & SAFETY
QUESTIONS?
CONTACT OUR PROFESSIONAL CUSTOMER
OR TEXT US MESSAGES AT
( (TEXT ONLY).

111
3
7
39

ATTENTION: The whole installation process requires at least
2 people to ensure safety and sturdiness.
Tip 1: Make sure the Letter
B on part B is facing up
Tip 2: USE SOME strength and
make sure Parts A and B are
securely clicked together.
2
Click!

Insert Part C to Parts A and B
(Need some strength to ensure sturdiness and leakproofness)
Make sure the hooks on the left side of Part B stuck in to the
bottom of Part C (see image below)
3
Click!

Insert two iron rods (Part D) into the
top of two Part A.
4

So far you have one Part C left. Go ahead and install it to
Parts A and B
(Need some strength to ensure sturdiness
and leakproofness)
Make sure the hooks on the short
side of Part B stuck into the
bottom of Part C
5
Click!
2

***IMPORTANT
Step 1: Use 6 screws to screw 3 Part T on to one of the iron rods.
Please choose the two holes on the right side.
DO NOT screw another iron rod in this step!
Step 2: Use one screw and screw Part I
on to the top-middle area of Part A,
right beside Part T.
AGAIN, leave another iron rod
UNSCREWED in this step.
6
7

7
Place the Part D onto Part J.
Scure Part D with 4 Part T and 8 screws
This step prevents the lid from bending causing by the sun
exposure and temperature variation.
8 4

Insert other 2 Part E‘s using the same method above.
DO NOT use too much strength, otherwise the parts would be damaged.
You are using Part J, Part E, Part G and 1 screw in this step.
***IMPORTANT:
a. First, insert 3 Part E's onto Part J.
Below are the illustrations:
Step 2: Use your thumb to push left to make some room for the
other side of Part E.
Step 3: Insert the other side of Part E into the hole.
8

Remember you left one iron rod unscrewed in Step 5.
In this step, you need to have your partner to hold Part J for you
to ensure safety and easy assmbly.
Like you can see from the picture in detail, use four screws to
install each Part E onto Part A.
By doing this, the iron rod on this side is also secured.
DANGEROUS: The partner should ALWAYS hold Part J to ensure
safety.
9
12

Installing the pressure bars
***IMPORTANT***
Use 5 screws for each side to install each pressure
bar on Part C and Part J
Your partner should always hold Part J during the
whole process to ensure safety.
10
0

Completed
11

CUSTOMER SERVICE:
CONTACT OUR PROFESSIONAL CUSTOMER SUPPORT AT
(TEXT ONLY).
12
1
1