BMG E3D V6 User manual

BMG E3D V6 Direct-Drive for Ender 3
Assembly Manual
YouMakeTech ©2022
Page 1

Step 1: Connect the E3D V6 hotend at the output of the BondTech BMG (PTFE tube length = 37 mm)
YouMakeTech ©2022
Page 2

Step 2: Insert the NEMA 1 Stepper motor into the BondTech BMG
YouMakeTech ©2022
Page 3

Step 3: Connect the BondTech E3D V6 assembly to the BMGV6 Plate
YouMakeTech ©2022
Page 4
M3x40 mm bolt

Step 4: Attach the assembly from Step 3 to the printer carriage (hole for Ender 3 Pro hown on picture)
YouMakeTech ©2022
Page 5
M3x8 mm bolt
M3x8 mm bolt

Step 5: Attach the BMG V6 back brace
YouMakeTech ©2022
Page 6
M3x45 mm bolt
M3x45 mm bolt

Step 6: Insert the 5015 blower fan into the fan duct
YouMakeTech ©2022
Page 7

Step : Insert 2x M3 nuts to attach the fan duct assembly
YouMakeTech ©2022
Page 8
M3 nut

Step Continued
YouMakeTech ©2022
Page 9
M3 nut

Step 8: Attach the fan duct assembly
YouMakeTech ©2022
Page 10
M3x20 mm bolt
M3x20 mm bolt

Step 9: Attach the BLTouch
YouMakeTech ©2022
Page 11
M3 nut (x2)

Step 9 Continued: Attach the BLTouch
YouMakeTech ©2022
Page 12
M3x8 mm bolt (x2)

Step 10: Attach cables to the base with 2 zip ties
YouMakeTech ©2022
Page 13
Zip tie (x2)