Boahaus Antheia Modern Bathroom Vanity User manual

BATHROOM VANITY
HARDWARE LIST
PART LIST
1
5
2
3
4
6
7

Step 1
AB
A
A
A
A
A
A
B
BB
B
B
B
B
B
B
B
B
Step 2
C
C
C
C
C
C
C
C
Step 3 Step 4
A
8x B
12x
Insert dowels (B) and cam bolts (A) into panels (1) and (2).
Fix cam bolts (A) with a phillips screwdriver.
*Do not use hammer.
2
1
A
C
8x
Insert cam locks (C) into panels (3) and (5).
3
5
5
3
1
5
5
4
355
2
Attach panels (3), (4) and (5) to panel
(1) tightening cam locks (C) applied in
eatch one with a phillips screwdriver.
Attach panels (2) to panels (3), (4) and (5) tightening cam
locks (C) applied in eatch one with a phillips screwdriver.
Before raise up the cabinet, it is recommended to install the foot
while the furniture is light (Step 8).

Step 5 Step 6
Step 7 Step 8
G
H
Attach handle (I) to panel (6) and (7)
with screw 3,5x45mm (E).
6&7
6&76&7
6&7
You can choose the way you want to
install the handle.
IE
E
E
E
I
WAY 1
WAY 2
Fit hinge plate (G) to hinge (H). After that, fit both
parts (H) and (G) to panels (6) and (7), and use screw
3,5x16mm (D) to fix them with a phillips screwdriver.
D
8x
G
4x
H
4x
Attach doors (6) and (7) to panels (1) and
(2) with screw 3,5x16mm (D), following
the marks.
D
8x
1 &2
D
D
F
F
FF
F
F
4x
- Install the nail foot (F) pressing them against
the panels (1) and (2).

Step 9
Vanity Top Installation
1. Set the vanity top on top of the vanity base, checking the location of the p-trap
and drain.
2. Remove the top and install the faucet per manufacturer’s installation instructions.
3. Hand tighten the pop-up drain with a wrench. Be careful not to over-tighten the
pop-up drain. Over tightening may cause cracks on the marble top.
4. Apply a thin bead of silicone compound around the vanity base and set the vanity
top carefully in place. Remove any excess silicone compound with a wet rag.
(SILICON NOT INCLUDED)
5. Install the faucet, water lines and P-trap according to manufacturer’s installation
instructions.
6. It is recommended to use the Without Overflow drain (NOT INCLUDED).