BOERBOEL EPN-5679 User manual

1
To register your product, please visit:
BoerboelGateSystems.com
Read all instructions prior to installing product.
Refer to manufacturers safety instructions when operating any tools.
10" GATE SPRING
Installation Instructions
EPN-5679

2
3
WARNING:
• Improper installation of this product can result in personal injury. Always wear safety goggles when
cutting, drilling and assembling the product.
• Incorrect installation may cause harm to the gate or individual.
NOTICE:
• DO NOT attempt to assemble the kit if parts are missing or damaged.
• DO NOT return the product to the store, for assistance or replacement parts call: 1-800-336-2383.
Component list:
QTY Description
1
Gate Spring
1
Tension Pin
1
Adjustment Rod
4
Philips Pan Head Screws
1
2
Mark Location:
a. Position spring with moveable mounting bracket
toward top of gate, angled to the right (Fig 1).
b. Mark screw locations on post and gate (Fig 2).
Installation:
a. Drill a 9/64" pilot hole through post and gate
(Fig. 3).
b. Fasten spring with provided screws (Fig. 4).
c. To increase tension, close gate and use provided
adjustment rod to turn tension barrel a maximum
of 3 increments. Holding the rod in place, insert the
tension pin in the open slot closest to the post on
the side opposite of the gate (Fig. 5).
d. Allow the tension barrel to return back towards
the post, which will have the tension pin resting up
against the fence locking it in place (Fig. 6).
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Gate Spring
Adjustment Rod
Tension Pin
Philips Pan Head Screws

BARRETTE OUTDOOR LIVING
7830 FREEWAY CIRCLE
MIDDLEBURG HEIGHTS, OHIO 44130
TEL: [phone]
WWW.BOERBOELGATESYSTEMS.COM