Power Output: TPU35B: 35W RMS; TPU60B: 60W RMS; TPU100B: 100W RMS; TPU250: 250W RMS
Frequency Response: 70 Hz to 15k Hz ±1 dB
Distortion: Less than 1%
Hum & Noise: (20 Hz to 20 kHz) MUSIC: -70 dB; TEL: -70 dB; MIC: -55 dB
Sensitivity: MUSIC: 85mV; TEL: -20 dBm (77mV); MIC: 600μV
Tone Control: BASS: ±9 dB @ 100 Hz; TREBLE: ±9 dB @ 10 kHz
Regulation: 2 dB
Inputs: TEL: 600-ohm balanced line, transformer-isolated
MUSIC: Hi-Z source, RCA jacks or screw terminals
MIC: Lo-Z balanced, screw terminal connection (dynamic only)
MUSIC MUTE: Mutes music when shorted
CONTACT RING: Sounds night ringer tone when customer-supplied dry
contacts are closed
TEL RING: Sounds night ringer in response to 90V ring signal
BRIDGING: Permits bridging of two amplifiers
Outputs: 25V, 25VCT, and 70V, 16 ohms balanced or unbalanced for 35/60/100-watt models;
25V and 70V for TPU250. Provision for WMT1A line-matching transformer
Controls & Indicators: POWER & PEAK LEVEL LED indicators. ENHANCE, TREBLE, BASS, VOX SENS,
RINGER VOLUME, MUSIC MUTE, MUSIC VOLUME, MIC VOLUME, TEL VOLUME,
ALC controls (screwdriver-adjustable)
Overload Protection: All models have thermal and electronic overload protection.
TPU35B: 1.0A, 120V AC circuit breaker; TPU60B: 1.6A, 120V AC circuit breaker;
TPU100B: 2.5A, 120V AC circuit breaker; TPU250: 6.0A slow blo fuse, 120V AC circuit breaker
Power Requirements: (120V AC, 60 Hz) TPU35B: 0.75A; TPU60B: 1.5A; TPU100B: 2A; TPU250: 5A
Thermal Emissions (Full Power):
TPU35B: 166.3 BTU/hr.; TPU60B: 211.7 BTU/hr.; TPU100B: 396.2 BTU/hr.; TPU250: 853.8 BTU/hr.
Finish: Black with silver lettering
Dimensions: TPU35/60/100B models: 14-1/4" W x 8-3/8" H x 3-5/8" D
TPU250: 19" W x 10-1/2" H x 3-7/8" D
Product Weight: TPU35B: 12 lb.; TPU60B: 15 lb.; TPU100B: 18 lb.; TPU250: 28 lb.
Technical
Specifications
Architect
and Engineer
Specifications
50 Spring Street, Ramsey, New Jersey 07446
201-934-8500 • Fax: 201-934-9832
www.bogen.com
The telephone paging amplifier shall be a Bogen Model
___, with a full power rating of ___ watts. (Specify:
TPU35B/35 watts, TPU60B/60 watts, TPU100B/100
watts, TPU250/250 watts.) The amplifier shall provide a
frequency response of ±1dB from 70Hz to 15kHz, and
shall deliver rated power at less than 1% distortion.
The amplifier shall permit paging from telephone and/or
microphone. The signal-activated paging channel shall
automatically mute background music during a telephone
page, eliminating the need for manual activation of
switches and the use of external relays. Provision shall be
included to set to mute the level of background music dur-
ing a page. Music level shall be returned to its normal
level after a page.
The telephone paging channel shall have a VOX sensitiv-
ity adjustment to eliminate transmission of background
noise, and automatic output leveling (ALC) to compen-
sate for varying voice levels and paging techniques of
persons using the system.
An Audio Enhancement circuit shall be included to regen-
erate the harmonics lost during the amplification process
and improve intelligibility. A control shall be provided to set
the level of this effect.
A night ringer shall be included to alert personnel of
incoming calls. The night ringer shall be activated by
a contact closure or by 90-volt ring signal from the
telephone line.
Input terminals shall be furnished for a telephone line and
Lo-Z balanced microphone. A choice of RCA jack or
screw terminals shall be provided for the music source.
Terminals shall also be provided to control music muting,
typically during a mic page, and for contact closure or ring
signal activation of the night ringer. Bridging jacks shall be
provided to bridge two TPU-series amplifiers.
Balanced or unbalanced outputs shall be provided for 16-
ohm, 25V, 25VCT, and 70V speaker lines (for TPU250,
25V and 70V only). Provision shall be included to drive a
600-ohm telephone line, using an accessory line-match-
ing transformer (Model WMT1A).
Individual controls shall be provided to set the telephone
and mic page volume, music volume, night ringer volume,
VOX sensitivity, and music mute level. Bass and treble
controls shall permit tonal adjustments. An automatic
level control (ALC) and VOX sensitivity control shall be
included. A peak level indicator shall illuminate when the
amplifier is driven into clipping. A power indicator shall
also be provided. The amplifier shall operate from a 120V
AC, 60Hz source, and shall be equipped with a resettable
circuit breaker and thermal and electronic overload pro-
tection (TPU250 has a 6A slow-blo fuse).
Installation shall be facilitated by flanges with keyhole
slots for mounting on a suitable backboard. Dimensions
for the 35, 60, and 100 models shall be 14-1/4" W x
8-3/8" H x 3-5/8" D. Dimensions for the TPU250 shall be
19" W x 10-1/2" H x 3-7/8” D.
The amplifier shall carry the necessary safety agency
listings for both U.S. and Canada.
