BOLD Overland Mailbox User manual

Overland Mailbox Installation
HAND MADE
BY TRUE
CRAFTSMEN
www.boldmfg.com
[email protected]
877-BOLD MFG
Printed in the USA
Installation must be performed by qualified personnel.
Measuring tape
Continued
Instructions:
Tools & Supplies:
Level
Wrench
Remove the 6 screws from the back with the screwdriver to remove the post that is inside.
Unscrew the nuts at the bottom to remove the post.
Locate the hole location around 18” back from the curb. Dig a hole 12” diameter and a little over
20” deep.
Once post is set, set the mailbox on top of the base plate. Use the included bolts to secure the
mailbox. Tighten the bolts with your wrench. Check that the mailbox is level. If not loosen bolts
and shim as neccessary.
Use the 6 screws to re-install the back panel and enjoy!
Shovel
Concrete
Bucket
Mix concrete per instructions on the bag. Pour the concrete into your hole and set the base post
at grade. Use your level to check that the baseplate is sitting level. Let the concrete cure (usually
a couple hours).
Phillips Screwdriver

www.boldmfg.com
[email protected]
877-BOLD MFG
Printed in the USA
Installation must be performed by qualified personnel.


Per U.S. Postal Service Standard – Mailboxes, Curbside, paragraph 3.12.1 Assembly and Installation:
A complete set of instructions for assembling and mounting the mailbox shall be furnished with
each unit. The instructions must include the following conspicuous message:
CUSTOMERS ARE REQUIRED TO CONTACT THE LOCAL POST OFFICE BEFORE INSTALLING THE MAILBOX TO ENSURE
ITS CORRECT PLACEMENT AND HEIGHT AT THE STREET. GENERALLY, MAILBOXES ARE INSTALLED AT A HEIGHT OF 41
- 45 in. FROM THE ROAD SURFACE TO INSIDE FLOOR OF THE MAILBOX OR POINT OF MAIL ENTRY (LOCKED DESIGNS)
AND ARE SET BACK 6 - 8 in. FROM FRONT FACE OF CURB OR ROAD EDGE TO THE MAILBOX DOOR.