Frontera KINGSLEY BATE User manual

KINGSLEY-BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE SR-15/25
SEAT BACK
STEP-I
Unpack, inspect and lay the parts on
a clean, flat, soft surface to avoid
marring the wood.
NOTE: During assembly of the
furniture please match all joints with
the corresponding letters or numbers
stamped on the furniture.
RIGHT END FRAME LEFT END FRAME
* NOTE:
A TENON
B MORTISE HOLE
STEP-II
Find the END FRAME with the stamped numbers
near the mortise holes and gently lay it down first.
Fit the BACK , BOTTOM LEG STRETCHER and
SEAT tenons into the end frame mortise holes as
shown in the photographs. NOTE: BOTTOM LEG STRETCHER ends are cut at an angle as
the chair flairs outward toward the front; there is a FRONT and BOTTOM to the part. If
necessary, gently rock the BACK FRAME while pushing tenons into mortise holes until joints
fit snugly together.
STEP-III
Fit the remaining end frame mortise holes over and onto all exposed
tenons.

STEP-IV
Drive all dowels into their respective holes as shown in the above pictures. All dowel holes
will be marked and it is important that you are careful not to use the wrong dowel in the
wrong hole. Do not force dowels further than they want to go; any excess can easily be
sanded away.
When doweling the BACK you can rest the edge on a table top as shown in the third
photograph (assistance is suggested). When doweling please use the sanding block between
the dowel head and the hammer head for the last few blows; this will prevent dimpling of the
wood by the hammer head. Again, DO NOT FORCE DOWELS further than they will go, you
can easily damage the teak by pushing the dowel through the piece.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]