BOLERO DL900 User manual

DL900 Beech Highchair
DL901 Dark Wood Highchair

IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY
Cleaning, Care & Maintenance
• Clean with a damp cloth.
• Polish with a suitable wood polish.
• Regularly tighten all screws.

Safety Tips
• Do not leave your child unattended. The safety of your child is your responsibility.
• Position on a flat, stable surface.
• Consult Local and National Standards to comply with the following:
• Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of
local authorities.
Pack Contents
The following is included:
BOLERO prides itself on quality and service, ensuring that at the time of packaging the contents are supplied
fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BOLERO dealer immediately.
WARNING!
IMPORTANT - KEEP FOR FUTURE
REFERENCE
DO NOT use the high chair unless all
components, are correctly fitted and adjusted.
Make sure that the harness is correctly fitted.
DO NOT use this chair if the child cannot sit up by
themselves.
DO NOT use the high chair if any part is broken.
Keep chair away from naked flames and intense
heat sources.
Note: Be sure to check all packaging materials for any small parts that may have come
loose during transportation.
• Health and Safety at Work Legislation
• BS EN Codes of Practice
• FirePrecautions
• Building Regulations
•Ax1
•Bx1
•Cx1
•Dx1
•Ex1
•Fx1
•Gx2
• Long Screw x 14 (H)
•Smallscrewx3(I)
•Washerx3(J)
•Lapstrapx1
•Crotchstrapx1
• Allen Key x 1

Assembly
1. Place Aon a flat stable surface.
2. Insert Cinto slot with short edge up.
3. Place Bonto C. Insert two screws and tighten slightly using the Allen key. Repeat for the other side.
4. Insert one Ginto slot at the back. Insert a screw and tighten slightly. Repeat for the other side.
5. Insert Dinto the slot. Insert a screw and tighten slightly. Repeat for the other side.
6. Slide Ethrough the loop of the crotch strap. Insert Einto slot. Insert a screw and tighten slightly.
Repeat for the other side.
7. Insert Finto slot. Insert a screw and tighten slightly. Repeat for the other side.
8. Insert second Ginto slot at the front. Insert a screw and tighten slightly. Repeat for the other side.
9. Tighten all screws.
10. Turn chair upside down and attach waist strap and crotch strap with washers and small screws to the
underside of the seat (as shown).
Compliance
BOLERO parts have undergone strict product testing in order to comply with regulatory standards and
specifications set by international, independent, and federal authorities.
This product conforms to: BS EN 14988: 2006: Parts 1 and 2
BOLERO Telephone Helpline: [phone]
BOLERO, Fourth Way, Avonmouth, United Kingdom, BS11 8TB
Note: During assembly, ensure that all screws are only loosely connected. Tightening
the screws as you go will make assembly difficult.