BOLERO Y813 User manual

Y813 Beech Highchair
Y814 Dark Wood Highchair

IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY
Cleaning, Care & Maintenance
• Clean with a damp cloth.
• Polish with a suitable wood polish.
• Regularly tighten all screws.

Safety Tips
• Do not leave your child unattended. The safety of your child is your responsibility.
• Position on a flat, stable surface.
• Consult Local and National Standards to comply with the following:
• Keep all packaging away from children. Dispose of the packaging in accordance with the regulations of
local authorities.
Pack Contents
The following is included:
BOLERO prides itself on quality and service, ensuring that at the time of packaging the contentsare supplied
fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BOLERO dealer immediately.
Assembly
1. Place Aon a flat stable surface.
2. Insert Cinto slot with short edge up.
3. Place Bonto C. Insert two screws and tighten slightly using the Allen key. Repeat for the other side.
4. Insert one Ginto slot at the back. Insert a screw and tighten slightly. Repeat for the other side.
5. Insert Dinto the slot. Insert a screw and tighten slightly. Repeat for the other side.
6. Slide the loop of the crotch strap over E. Insert Einto slot. Insert a screw and tighten slightly. Repeat
for the other side.
7. Insert Finto slot. Insert a screw and tighten slightly. Repeat for the other side.
8. Insert second Ginto slot at the front. Insert a screw and tighten slightly. Repeat for the other side.
9. Tighten all screws.
10. Turn chair upside down and attach waist strap and crotch strap with washers and small screws to the
underside of the seat (as shown).
WARNING!
DO NOT use the high chair unless all components are correctly
fitted and adjusted.
DO NOT use this chair if the child cannot sit up by themselves.
DO NOT use the high chair if any part is broken.
Keep chair away from naked flames and intense heat sources.
Note: Be sure to check all packaging materials for any small parts that may have come
loose during transportation.
Note: During assembly, ensure that all screws are only loosely connected. Tightening
the screws as you go will make assembly difficult.
• Health and Safety at Work Legislation
• BS EN Codes of Practice • FirePrecautions • Building Regulations
•Ax1
•Bx1
•Cx1
•Dx1
•Ex1
•Fx1
•Gx2
• Long Screw x 14 (H)
•Smallscrewx3(I)
•Washerx3(J)
•Lapstrapx1
•Crotchstrapx1
• Allen Key x 1

Compliance
BOLERO parts have undergone strict product testing in order to comply with regulatory standards and
specifications set by international, independent, and federal authorities.
This product conforms to: BS EN 14988: 2006: Parts 1 and 2
BOLERO Telephone Helpline: [phone]
BOLERO, Fourth Way, Avonmouth, United Kingdom, BS11 8TB