Bond BH65003-9 User manual

DANGER
WARNING
FIRE OR EXPLOSION HAZARD
If you smell gas:
Shut off gas to the appliance.
Extinguish any open flame.
If odor continues, leave the area immediately.
After leaving the area, call your gas supplier
or fire department.
Failure to follow these instructions could
result in fire or explosion, which could cause
property damage, personal injury, or death.
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance. An LP-cylinder not connected
for use shall not be stored in the vicinity of
this or any other appliance.
•
•
•
•
DANGER CARBON MONOXIDE HAZARD
This appliance can produce carbon
monoxide which has no odor.
Using it in an enclosed space can kill you.
Never use this appliance in an enclosed
space such as a camper, tent, car or
home.
INSTALLER: Leave this
manual with the appliance.
CONSUMER: Retain this
manual for future reference.
WARNING
WARNING: If the information in this
manual is not followed exactly, a fire or
explosion may result causing property
damage, personal injury, or loss of life. or the gas supplier.
by a qualified installer, service agency,
Installation and service must be performed
WARNING:For Outdoor Use Only.
service agency, or the gas supplier.
with this appliance. Installation and service must be performed by a qualified installer,
damage, personal injury or loss of life. Refer to the owner's information manual provided
Improper installation, adjustment, alteration, service or maintenance can cause property
Model# BH65003-9
Item# 52296
MURPHY EXTERIOR GAS FIRE PIT
User Guide

Page 2
SAFETY INFORMATION
WARNING
Before you assemble or operate this unit, please carefully read this entire manual. Failure to do so
may r
•
•
•
•
•Manifold pressure: 11 inch w.c. (2.74kPa).
•
•
•
•The tank system must be set up for vapor withdrawal.
•Discontinue use if any part of the propane tank is damaged. Rust and dents may be hazardous and
should be inspected by a gas supplier.
•
•
rocks/pumice stones/LavaGlass®could pop out and cause injury. Should any rocks pop out, discard
them.
• Always ensure that lava rocks/pumice stones/LavaGlass®are completely dry before use. Failure to
do so will cause them to crack or pop.
•Do not operate unit until all parts are fully assembled.
•Do not paint or color any part of this heating unit.
•Unit may be hot while in use, do not attempt to move it while in use.
•Never leave this heating unit unattended while in use.
•This unit is not intended for cooking.
•
•Keep a safe distance to avoid burning skin or clothing.
•Do not sit or rest hands or feet on this heating unit.
•
•Keep all electrical cords and fuel supply hose away from heated surfaces.
The installation of this unit must adhere to local codes or Propane Storage and Handling Code,
CSA B149.2.
pit.
•Cover must be removed when burner is in operation.
•Solid fuels shall not be burned in this appliance.
•Only use propane gas for this unit. (sold separately)
•Do not attach a remote gas supply to this unit.
ventilated space and shall not be used in any enclosed area.
•THIS UNIT IS INTENDED FOR OUTDOOR USE ONLY! This product shall be used outdoors, in a
LavaGlass®above the burner holes. Doing so will suffocate the flame.
LP GAS WARNING: Do not use any more than 1/4 in (6.3 mm) depth lava rocks/pumice stones/
supplier or re department for help.
1. Disconnect the propane tank. 2. Do not attempt to x the problem yourself. 3. Contact your gas
•If the propane tank is leaking gas, you may see or smell it, or hear a hiss. Do the following:
the unit so that the remaining gas may escape.
•Applying too much propane may cause a gas accumulation and will not burn. Allow fresh air into
You must use a propane tank that has a collar to protect the gas valve.
and capacity 20 lb (9 kg).
Use LP propane tanks with the following features: diameter 12 in (30.48 cm), height 18 in (45.72 cm)

Page 3
• Combustible material should not be within 60 in (1.52 m) of the top of the unit, or within 48 in (1.21 m)
around the entire unit.
• Keep the appliance area clear and free fr
vapors and liquids.
•
of the U.S. Department of Transportation or the National Standard of Canada CAN/CSA-B339, LP gas
tanks, spheres and tubes for Transportation of Dangerous Goods and Commission.
gas tank connection.
cks.
•Children and adults should be alerted to the hazards of high surface temperatures and should
stay away to avoid burns or clothing ignition.
•Young children should be carefully supervised when they are in the area of the appliance.
near the appliance.
•Any guard or other protective device removed for servicing the appliance shall be replaced
prior to operating the appliance.
(CGA791) LP
•If you store the heating unit indoors, detach the propane tank and leave outdoors.
•Do not store a spare propane tank on or near this unit.
•Do not disconnect any part while unit is in use.
control that has been under water.
technician to inspect the appliance and replace any part of the control system and any gas
•Do not operate unit if any part has been under water. Immediately call a
•Do not add water into the unit.
•Maximum gas supply: 250 psi; Min. gas supply: 10 psi.
•Keep gas tank at least 60 in (1.52 m) away from unit when lit.
•Children should never operate this unit. Children must be supervised while near this unit.
•Check for leaks after not using the unit for long periods of time.
•Do not set the protective cover over the unit until it is turned off and completely cooled down.
•Always remove protective cover before operating (if applicable).
injury.
•Be aware of the hazards of high temperatures and stay away from the unit to avoid any burns or
•Keep the hose out from any pathways to eliminate any accidental damage.
replaced.
•Inspect all elements of this heating unit before each use. If there is damage, the burner must be
inspected annually and cleaned regularly.
•DO NOT use heating unit while lid is installed. Always remove the lid while heating unit is in use.
•Allow heating unit to cool completely before placing on lid.
IF APPLICABLE:
circulating airways of the appliance are kept clean.
may be required as necessary. It is imperative that the control compartment, burners and
•The gas supply tank should be constructed and marked with the specifications for the LP gas tanks

Page 4
SAFETY INFORMATION
Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
Combustible materials should not be within 60
inches of the top of the unit, or within 48 inches
around the entire unit.
Always place this outdoor fire pit on a hard, level,
non-combustible surface such as concrete, rock or
stone.
DANGER
valve is turned "OFF" before assembling. Do NOT attempt to assemble without proper tools.
NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas
at 1-877-447-4768.
appliance. For assistance with repair or replacement of the burner or any other parts, call manufacturer
Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate the
directly by manufacturer.
Only use the regulator and hose assembly provided with this unit. Replacement parts must be supplied
Before beginning assembly of product, make sure all parts are present. Compare parts with
package contents list and hardware contents list. If any parts are missing or damaged, do not
attempt to assemble the product.

Page 5
CONTENTS
Item Description Qty
A Lava Rocks 2 boxes
B Battery (AAA) 1
C Body 1
D Tank Holder 1
E Protective Cover 1
F Control Knob (preassembled) 1
G Electronic Igniter (preassembled) 1
H Burner (preassembled) 1
I Guard (preassembled) 1
J4
Feet (pressambled)
G
A
B
C
D
E
F
H
I
J

ASSEMBLY INSTRUCTIONS
DANGER
3.
CYLINDER VALVE
PRESSURE
RELIEF VALVE
BLEED-OFF
VALVE
BLACK COUPLING NUT
REGULATOR
turn clockwise to connect
turn clockwise
to reseal
RUBBER O RING
Turn the cylinder valve on the tank
clockwise to close the propane tank.
Attach the preassembled regulator
from the body to the cylinder valve
by turning the regulator coupling nut
clockwise. Make sure it is fastened
securely and tighten connections by
hand only.
D
Page 6
1. Check that the control knob (F) for the gas
supply system is turned to the “OFF” position
before starting any assembly.
OFF
F
tighten the tank into the tank holder.
the outside of the tank holder (D) clockwise to
into the tank holder (D). Turn the wing screw on
2. Put the 20 lb propane gas tank (not included)
and serious injury by propane tank.
rubber O ring can cause leaks, explosions
worn before attaching regulator. Worn
propane tank valve to ensure it is not
Please inspect the rubber O ring in the
WARNING
away at all times.
Propane tank must be a minimum of 60 in (1.52 m)

Page 7
4. Remove the rubber cap on the electronic igniter
(G) by unscrewing and slide battery (B) into the
battery slot. Make sure the positive side of the
battery faces outwards. Screw the electronic
igniter cap (G) over the battery tightly.
G
B
5.
body (C).
A
I
C
to do so will cause them to crack or pop.
LavaGlass®
are completely dry before use. Failure
Always ensure that lava rocks/pumice stones/
Keep away from the unit and allow the unit to burn
burner (H) should be free of lava rocks at all times.
To ensure proper functioning, the guard (I) on this
WARNING

OPERATION
Page 8
To Light
WARNING
If the burner does not ignite with the burner
control valve open, gas will continue to flow
out of the burner and could accidentally ignite
causing injury or property damage.
OFF
LOW
IGNITER
HIGH
OFF
LOW
IGNITER
HIGH
10 in.
25 cm.
2 in.
5 cm.
60”
instructions.
position. Wait for 5 minutes for gas to clear and then repeat the above lighting
If ignition doesn’t occur within a few seconds, release the control knob (F) and rotate to the "OFF"
Push in the control knob (F) and turn on the "LOW"position. Keep holding down the control knob
(F) to allow gas to flow for 15 seconds.
Push and hold in the electronic igniter (G) to create sparks within the electrode, continue to hold.
tank by turning the knob counterclockwise.
.
Make sure the control knob (F) is in the "OFF"position. Slowly open the valve on the propane
1
To Extinguish
.
Turn control knob (F) clockwise to the "LOW"position; let the knob pop up and continue turning
1
the control knob (F) to the "OFF" position.
.
Close the cylinder valve on the propane tank if you don’t intend to use it for a long time.
2
Once the fire product is lit, the flame intensity may be controlled by turning the control knob (F)
between the "LOW" and "HIGH" position.
5.
4.
3.
2.
WARNING
of each other.
kept at a minimum distance of 60 in (1.52 m)
The heating unit and the propane tank must be
you must replace the hose (if applicable). Pumice stones/lava rocks/LavaGlass®could pop up and
Do not use the heating unit without inspecting the gas hose. If there are signs of wear or abrasion,
repaired.
gas valve off, disconnect propane tank and do not use the appliance until the leak is
occur on any connection there may be a leak. If you smell gas or a leak is discovered, turn the
position. Brush a soap and water mixture on all connections. Turn the gas supply on. If bubbles
area. Connect the propane tank to the regulator and turn the valve on the unit to the "OFF"
Before performing a leak test, be sure that no sparks can occur and you are in a spacious outdoor
(25 cm) in height.
20 minutes after igniting. Flame height should be a yellow/blue colour between 2 in (5 cm) and 10 in
Wait 50 minutes after extinguishing flame prior to placing a lid (if applicable) or protective cover on
heating unit.

MAINTENANCE
Page 9
•Always place lid (if applicable) or protective cover on heating unit when not in use.
and void the warranty of this heating unit.
•Not using manufacturer approved or supplied parts/accessories may result in a defective condition
•If storing this unit inside, disconnect the propane tank from the gas valve.
•Keep the heating unit stored away from direct sunlight.
components on this heating unit.
•Permanent damage may occur if powder or solvent comes in contact with painted or plastic
•Harsh weather conditions may cause stubborn stains, discoloration and possibly rust pitting.
lava rocks/LavaGlass®are completely cooled down. Wipe down with a soft cloth.
•Use a soft brush to get rid of the mild stains, loose dirt and soil after the burner and pumice stones/
•Visually inspect burner for obstructions and keep tank enclosure free and clear from debris.
•Keep the heating unit free and clear from combustible materials.
prevent from damage.
•Store your appliance indoors during winter months. Avoiding extreme cold temperatures will
•Before performing any maintenance, always disconnect propane tank.

TROUBLESHOOTING
Page 10
Problem Cause Solution
Igniter pin and burner are wet Dry off with a soft cloth
Igniter battery is incorrectly inserted
Igniter pin is broken
Electrode wire is loose or disconnected Reconnect wire to the igniter box located
inside the unit behind the igniter box
Electrode wire is shorting between valve
and igniter pin
No gas flow Check that the gas tank isn’t empty
Regulator isn’t connected securely to the
tank
Tighten regulator connection to the gas
tank
Gas flow is obstructed Check all hoses for kinks and bends
Burner ports are clogged Turn all gas flow connections off. Insert
an opened paperclip (or similar item) into
each of the burner ports to clear them
out.
Flame is obstructed at burner ports Check that all burner ports are free of any
small lava rocks/pumice stones/Lava-
Glass®pieces
Regulator hose is kinked Straighten hose of all bends or kinks
No gas flow Check that the gas tank isn’t empty
Excess flow safety valve has been
activated
High or gusting winds
No gas flow Check that the gas tank isn’t empty
Excess flow safety valve has been
activated
Heating unit won’t light
Burner won’t light
while using a match
Heating unit emits a lot
of black smoke
Sudden drop in gas
flow
Flame blows out easily
inserted
Check in which direction the battery is
this guide.
as indicated in the "To Light"section of
nect propane gas tank. Light the fire unit
knob back to the "OFF"position. Recon-
to "HIGH"; wait 1 minute. Turn the control
propane gas tank. Turn the control knob
tion. Close the tank valve and disconnect
Turn the control knob to the "OFF"posi-
Increase flame to "HIGH"
See "sudden drop in gas flow"above
replacement part
Contact the manufacturer for a
replacement part
Contact the manufacturer for a