Bonito WireRun User manual

ASSEMBLY INSTRUCTIONS
Tools Needed:
Jig Saw or Hole Saw
IMPORTANT: ALWAYS WEAR SAFETY GLASSES WHEN
DRILLING OR CUTTING
Making the hole
Decide where you would like to install the Bonito
Power Grommet on your desk, furniture, table or
other surface.
Use the hole-cutting template on the back of this
page or your preferred method to mark cutting
guidelines.
Using a hole saw or jig saw, create a 4.21” (107mm)
diameter hole.
1
2
3
installing the bonito Power Grommet in
the hole
1
2
Attach the two
metal clips onto the both
sides of the unit by inserting
the clips into the slots as
shown.
Note: the clips are also available
in the provided hardware kit.
Bend the clips on both sides
before the installation.
Bend the clips on both sides
Attach the two
metal clips onto the both
sides of the unit by inserting
the clips into the slots as
Note: the clips are also available
in the provided hardware kit.
ire un

Hole Cut Size = 4.21” (107mm)
3Place the cord in hole rst,
then set the entire unit
(with both clips) into the
pre-cut hole of the desk,
furniture, table
or other surface.
4Installation is complete.
Installation is complete.
sliding button
Operation
To ip the Bonito Power Grommet
up and down, simply slide the
button and it will lock into place.
To ip the Bonito Power Grommet
up and down, simply slide the
button and it will lock into place.
www.wirerun.net • 1-844-944-1031 • 6250 NW 27th Way, Fort Lauderdale, FL 33309
sliding button
Product Warranty: Wire Run warrants its product for period of one year
from date of purchase. We will repair or replace any product found to be
defective in material or workmanship during the warranty period.
ire un
Choking Hazard:
Keep small parts and plastic bags away from children.