BORK S511 User manual

JUICER S511
OPERATING MANUAL

OPERATING MANUAL
JUICER
S511

2 3
DESCRIPTIONDESCRIPTION
2 3
75ММ WIDE FEED CHUTE
The feed chute diameter allows you to handle whole products, which means no
more cutting. Thanks to this, you can now get more juice in less time.
FINE MESH FILTER WITH TITANIUM
NITRIDE BLADES COATING
Thanks to the fine mesh filter with unmatched filtering properties, you can
get the purest juice and the driest pulp. The titanium nitride coating enhances
the resistance of blades to wear, oxidation and corrosion to make them more
durable and ensure the best results.

4 5
DESCRIPTIONDESCRIPTION
4 5
SAFETY AND RELIABILITY
Smooth motor start, overheating protection and electronic overspeed limiter
ensure high reliability and operational safety of the juicer.
Apricots Low
Pineapple High
Oranges (peeled) High/Low
Watermelon Low
Broccoli Low
Grapes (without kernels) Low
Pears (solid) High
Pears (soft) Low
Melons Low
Cabbage Low
Brussels sprouts High
Cauliflower Low
Kiwi Low
Strawberry Low
Raspberry Low
Mango Low
Carrots High
Cucumber Low
Peaches Low
Beet root High
Celery High
Plums Low
Tomatoes Low
Pumpkin High
Blackberry Low
Apples High
TWO EXTRACTION SPEEDS FOR SOFT AND SOLID PRODUCTS
To juice different products different number of rotations is needed. The juicer can operate at two extraction speeds: low – for soft
products – 6,500 rpm (Low position) and high – for solid products – 13,000 rpm (High position).

6 7
CONFIGURATIONCONFIGURATION
1 l juice jar with froth separator
Fine mesh filter with titanium nitride blades coating
Brush to clean the filter
Nozzle for extraction in a glass
75 mm wide feed chute
Allows to load whole products, without cutting into parts
Lid block
The juicer is not ready for operation until
the lid block is in the vertical position
2 liter pulp container
Speed control
Two extraction speeds for soft products — 6,500 rpm
and solid products — 13,000 rpm
Pusher for products
Filter cup
Juicer’s lid
Base with motor
Motor power: 950 Wт

8 9
ASSEMBLYCONFIGURATION
NOZZLE FOR EXTRACTION IN A GLASS
You can use any dish instead of the juice jar.
The nozzle for extraction in a glass will prevent
splashing during extraction. It also has the “drop
stop” function. For that purpose turn the nozzle
with its nose up.
BEFORE THE FIRST USE
Unpack the juicer. Remove all packing materials,
squibs and labels from the juicer’s casing and base.
Before the first use wash all removable parts
of the juicer with running water and wipe the
base with the motor with a wet napkin to remove
all mechanical parts and dust, which could get
inside the juicer in the course of manufacture and
transportation. • Set the filter cup on the base with the motor. • Set the filter by aligning arrows on the filter with
arrows on the filter drive.
Make sure that the filter is safely fixed inside the
filter cup.

10 11
ASSEMBLYASSEMBLY
• Set the pulp container slightly declining it. • Place the juice jar under the juicer’s nose. Put
the lid with the separator on the jar to prevent
splashes.
• Set the juicer’s lid on the filter cup. • Lift the lid block in the vertical position until you
hear a click.
• Insert the pusher for products into the feed
chute.

12 13
DISMANTLINGOPERATION
Never push products in the feed chute with hands.
Do not attempt to clean the chute manually. Use the
pusher for products included in the set.
When you extract juice in any other dish use the
nozzle for extraction in a glass to prevent splashing.
• Switch off the juicer by setting the switch into the
Off position. Unplug the appliance.
• Remove the pulp container holding it by the
handle.
• Wash products prepared for juicing with running
water.
Make sure that the juicer is correctly assembled.
• Plug in the juicer and set the speed control into
position Low or High depending on the selected
product.
Refer to the table on page 11 to select a correct
extraction speed.
• Supply products into the feed cute with a pusher.
To minimize cleaning put a plastic bag inside the
pulp container in advance. Then you can simply
throw it away.

14 15
DISMANTLINGDISMANTLING
• Take off the filter cup.• Open the lid block holding the juicer and move
it down.
• Take off the juicer’s lid. • To extract the filter turn the juicer’s nose to the
left.
Do not touch sharp blades in the filter’s base.

16 17
CLEANINGSAFETY PRECAUTIONS
Before cleaning always unplug the appliance.
Caution! Never immerse the juicer’s casing, the
power cord or the plug of the power cord into
water or any other liquid. Avoid formation of water
condensate thereon and do not use the juicer in
places with increased humidity.
Advice. To facilitate cleaning after usage fill the
operating juicer with 1-2 glasses of warm water.
CLEANING OF THE EXTERNAL PART OF
THE JUICER’S CASING
First wipe the external part of the juicer’s casing
with a wet napkin soaked in a soapy solution and
then with a soft napkin or use a special agent for
cleaning of plastic surfaces.
CLEANING OF THE FILTER
After each use carefully wash the filter with the
brush included in the set. After washing look
though the filter to make sure that the filter holes
are not blocked.
To facilitate cleaning put the filter into hot soapy
water for 10 minutes immediately after usage.
Caution! Exercise caution. Sharp blades are located
in the filter base.
You can wash the juicer’s lid, filter cup, pulp
container and juice jar in the dishwasher.
• Keep this operating manual, so that it can be
referred to in the future.
• The juicer is not meant for operation by
unattended children.
• During cleaning of the juicer observe the
instructions specified in section “Cleaning”.
• Never immerse the juicer’s casing, the power
cord or the plug of the power cord into water or
any other liquid.
• Do not touch the sharp blades in the filter base.
• Before operation make sure that the juicer is
correctly and entirely assembled.
• Use the juicer to make juices from vegetables,
fruit, berries and greens.
• Use the juicer for the purpose specified.
• Remove kernels from all fruit with solid seeds,
such as: nectarines, peaches, mango, apricots,
plums and cherries.
• For safety reasons all operations on repair and
maintenance of the juicer shall be performed
only by authorized representatives of BORK
certified service centers.
• Caution! The feed chute is very wide. Do not put
hands and foreign objects in the feed chute.
• Always use the pusher for products included in
the set.

18
SPECIFICATIONS
Voltage: 220–240 V
Frequency: 50–60 Hz
Power: 800–950 W
The manufacturer reserves the right to make
changes to specifications as a result of continuous
product updating without additional notice thereon.
CONFIGURATION
Juicer: 1
Juice jar: 1
Pulp container: 1
Nozzle for extraction in a glass: 1
Brush to clean the filter: 1
Operating manual with guarantee card: 1 pc.