Bosch HSG9583 Series User manual

Video | HSG9583 Series Outdoor Camera Housing
HSG9583 Series Outdoor Camera Housing
www.boschsecurity.com
uNEMA-3R and IP55 enclosure ratings
uProtects Camera/Lens Combinations up to 262 mm
(12.5 in) Length
uHinged Side Opening for Easy Installation and
Camera Setup
uAluminum and Advanced Polymer Construction
uSunshield Included
The HSG9583 Series Housings are smartly styled
housings, for outdoor use. These housings meet
customer requirements for camera enclosures that are
both cost-competitive and installer-friendly. Models
are available for use with 24 VAC, 115 VAC, and
230 VAC cameras, to fit a wide range of applications.
The unique hinged side-opening design facilitates easy
installation of all camera/lens combinations, and
allows access to most camera and lens controls when
the housing is in its mounted position. Power, video,
and lens control cabling can be routed through liquid-
tight fittings in the bottom rear of the housing, or for
even better cable management, via the feed-through
entry holes in the base. Mounting holes in the base
permit installation to a wide range of pan/tilts,
adjustable heads, and various camera mount brackets.
External 4-pin and BNC connectors for power and
video, located in the rear end cap, are also available
on 24 VAC and 230 VAC models. These aluminum
constructed housings are available with a factory-
installed heater and blower. The heater maintains the
internal temperature of the housing in cold
temperature conditions as low as -40°C (-40°F). In
combination with a continuous-duty blower, the unit
minimizes fogging in high humidity locations, and
extends the temperature limits. Sunshields are
included on all outdoor models.
All models accommodate installation of Dinion style
cameras with fixed focal, varifocal, or up to a 15x
motorized zoom lens.
For increased security, tamper-resistant screws are
provided for the locking clasps to prevent unwanted
access to the housing contents.
With a sleek design that meets NEMA-3R and IP55
enclosure standards, the HSG9583 Series Housings
are the optimal solution for protecting your video
surveillance equipment from adverse elements.
Installation/Configuration Notes
480
18 . 9
119
4.7
mm
in
434
17.1
275
10 . 8
50.8
2.0
19 . 6
.77
128
5.0
14 8
5.8
90.0
3.54
73.7
2.9
13 0
5.1
14 8
5.8
HSG9583/20 /21 /50 /51 /61 Housings Outdoor Units

480
18 . 9
434
17
13 0
5.2
119
4.7
270
10 . 6
50.8
2.0
19 . 6
.77
90.0
3.54
73.7
2.9
8.2
0.33
HSG9583/22 /52 /53 Housings Outdoor Units
H
W
L
262
10 . 3
mm
in
81
3.2
89
3.5
All Models
Maximum internal usable space available (based on
camera/lens size)
Note:
Allowance is provided for wiring and connector space
requirements
Technical Specifications
Electrical/Mechanical
Fittings and Connectors
HSG9583 /20, /
21, /50, /51, /61
Three (3) liquid-tight rear fittings, two (2) of
which accept cable diameters from 4.0 mm to
7.0 mm (0.16 in to 0.28 in); one (1) that
accepts cable diameters from 6.5 mm to
10.5 mm (0.26 in to 0.42 in) Two (2) bottom
feed-through liquid tight fittings accept cable
diameters from 4.0 mm to 7.0 mm (0.16 in to
0.28 in)
HSG9583 /22, /
52, /53
Rear-mounted 4-pin connector for power, with
mating connector Rear-mounted BNC connector
for video
Window 3 mm (0.12 in) glass
Housing Mounting Four (4) available 1/4-20 tapped holes; One pair
of holes on 50.8 mm (2.0 in) centers, second
pair on 73.7 mm (2.9 in) centers. Only one set
of two is required for mounting
Camera Mounting Removable camera/lens tray, mounted with two
screws
Construction Aluminum housing casing, neoprene gaskets,
UV-resistant polymer endcaps, and all stainless
steel hardware
Tamper-resistance Tamper-resistant screws for locking clasps are
provided
Finish Gray
Dimensions See drawings
Weight
HSG9583/20, /
50, /52
2.8 kg (6.1 lb)
HSG9583/21, /
22, /51, /53, /61
2.9 kg (6.4 lb)
Environmental
Operating Temp. With heater/blower accessories installed:
With fixed lens: at an external temperature of
-40 °C to +50 °C (-40 °F to +122 °F), the housing
will maintain the internal temperature between
-20 °C and 55 °C (-4 °F to +131 °F).
With zoom lens: at an external temperature of
-30 °C to +50 °C (-22 °F to +122 °F),the housing
will maintain the internal temperature between
-10 °C and 55 °C (+14 °F to +131 °F).
Enclosure
Protection
IP55, NEMA-3R
Product Regulatory Compliance
Product Safety Complies with CE regulations, UL, CSA, EN, and
IEC Standards
Enclosure
Protection
NEMA-3R and IP55
Ordering Information
HSG9583/20 Outdoor Housing
for camera/lens up to 262 mm (10.3 inch), 24 VAC,
50/60 Hz, heater, sunshield, feed-through cabling
Order number HSG9583/20
HSG9583/21 Outdoor Housing
for camera/lens up to 262 mm (10.3 inch), 24 VAC,
50/60 Hz, heater, blower, sunshield, feed-through
cabling
Order number HSG9583/21
HSG9583/22 Outdoor Housing
for camera/lens up to 262 mm (10.3 inch), 24 VAC,
50/60 Hz, heater, blower, sunshield, outside BNC
connector and outside power connector
Order number HSG9583/22
2 | HSG9583 Series Outdoor Camera Housing

HSG9583/50 Outdoor Housing
for camera/lens up to 262 mm (10.3 inch), 230 VAC,
50/60 Hz, heater, sunshield, feed-through cabling
Order number HSG9583/50
HSG9583/51 Outdoor Housing
for camera/lens up to 262 mm (10.3 inch), 230 VAC,
50/60 Hz, heater, blower, sunshield, feed-through
cabling
Order number HSG9583/51
HSG9583/52 Outdoor Housing
for camera/lens up to 262 mm (10.3 inch), 230 VAC,
50/60 Hz, heater, sunshield, outside BNC connector
and outside power connector
Order number HSG9583/52
HSG9583/53 Outdoor Housing
for camera/lens up to 262 mm (10.3 inch), 230 VAC,
50/60 Hz, heater, blower, sunshield, outside BNC
connector and outside power connector
Order number HSG9583/53
HSG9583/61 Outdoor Housing
for camera/lens up to 262 mm (10.3 inch), 115 VAC,
60 Hz, heater, blower, sunshield, feed-through cabling
Order number HSG9583/61
Accessories
LTC 9215/00 Mount
Wall mount for LTC/HSG 948x, HSG9583 and UHI/UHO
housings
Order number LTC9215/00
LTC 9215/00S Mount
Short wall mount for LTC/HSG 948x, HSG9583 and
UHI/UHO housings
Order number LTC9215/00S
LTC 9219/01 J-Mount
Feed-through J‑ mount for LTC/HSG 948x, HSG9583
and UHI/UHO housings
Order number LTC9219/01
HAC-SUNSH-0 Sunshield
Sunshield for HSG9483 and HSG9583
Order number HAC-SUNSH-0
HAC-TAMP01 Tamper Switch
Tamper switch kit for HSG and UHI/UHO series
enclosures
Order number HAC-TAMP01
3 | HSG9583 Series Outdoor Camera Housing

HSG9583 Series Outdoor Camera Housing
HSG9583/20
Outdoor Housing
HSG9583/21
Outdoor Housing
HSG9583/22
Outdoor Housing
HSG9583/50
Outdoor Housing
HSG9583/51
Outdoor Housing
model Outdoor Unit Outdoor Unit Outdoor Unit Outdoor Unit Outdoor Unit
Installed Accessory Htr, SS Htr, Blr, SS Htr, Blr, SS Htr, SS Htr, Blr, SS
Voltage/Power 24 VAC / 30 W 24 VAC / 35 W 24 VAC / 35 W 230 VAC / 30 W 230 VAC / 35 W
Camera Ratings 24 VAC 24 VAC 24 VAC 230 VAC 230 VAC
Maximum Camera/
Lens Size
81 x 89 x 262 mm 81 x 89 x 262 mm 81 x 89 x 262 mm 81 x 89 x 262 mm 81 x 89 x 262 mm
W x H x L (3.2 x 3.5 x 10.3 in.) (3.2 x 3.5 x 10.3 in.) (3.2 x 3.5 x 10.3 in.) (3.2 x 3.5 x 10.3 in.) (3.2 x 3.5 x 10.3 in.)
HSG9583/52
Outdoor Housing
HSG9583/53
Outdoor Housing
HSG9583/61
Outdoor Housing
model Outdoor Unit Outdoor Unit Outdoor Unit
Installed Accessory Htr, SS Htr, Blr, SS Htr, Blr, SS
Voltage/Power 230 VAC / 30 W 230 VAC / 30 W 115 VAC / 35 W
Camera Ratings 230 VAC 230 VAC 115 VAC
Maximum Camera/
Lens Size
81 x 89 x 262 mm 81 x 89 x 262 mm 81 x 89 x 262 mm
W x H x L (3.2 x 3.5 x 10.3 in.) (3.2 x 3.5 x 10.3 in.) (3.2 x 3.5 x 10.3 in.)
4 | HSG9583 Series Outdoor Camera Housing
Represented by:
Americas: Europe, Middle East, Africa: Asia-Pacific: China: America Latina:
Bosch Security Systems, Inc.
130 Perinton Parkway
Fairport, New York, 14450, USA
Phone: [phone]
Fax: [phone]
[email protected]
www.boschsecurity.us
Bosch Security Systems B.V.
P.O. Box 80002
5617 BA Eindhoven, The Netherlands
Phone: + 31 40 2577 284
Fax: [phone]
[email protected]
www.boschsecurity.com
Robert Bosch (SEA) Pte Ltd, Security
Systems
11 Bishan Street 21
Singapore 573943
Phone: [phone]
Fax: [phone]
[email protected]
www.boschsecurity.asia
Bosch (Shanghai) Security Systems Ltd.
201 Building, No. 333 Fuquan Road
North IBP
Changning District, Shanghai
200335 China
Phone [phone]
Fax: [phone]
www.boschsecurity.com.cn
Robert Bosch Ltda Security Systems Division
Via Anhanguera, Km 98
CEP 13065-900
Campinas, Sao Paulo, Brazil
Phone: [phone]
Fax: [phone]
[email protected]
www.boschsecurity.com
© Bosch Security Systems 2012 | Data subject to change without notice
2094967819 | en, V1, 11. Sep 2012