-5-
skin, wash quickly with soap and water. If the
liquid contacts your eyes, flush them with
water for a minimum of 10 minutes and seek
medical attention.
$9.0205.?42?<;39.A ;<;39.::./92
@B?3.02@ .;1 .D.F 3?<: 39.::./92
:.A2?6.9@ D52; ?205.?46;4 /.AA2?F =.08
The charger and battery pack heat during
charging. Carpeting and other heat insulating
surfaces block proper air circulation which
may cause overheating of the charger and
battery pack. If smoke or melting of the case
are observed unplug the charger immediately
and do not use the battery pack or charger.
(@2
<3.;.AA
.05:2
;A
;<A?20
<::2;
12
1<?
@<91/F<@05:.F?2@B9A6;.?6@8 <336?2
2920A?60@5<08<?6;7B?FA<=2?@<;@
.AA2?F.?2
*52;
/.AA2?62@
.?2
;<A
6;
A<<9 <? 05.?42? 822= A52:
.D.F 3?<: :2A.9 </720A@ For example, to
protect terminals from shorting #H"#'
place batteries in a tool box or pocket with
nails, screws, keys, etc. Fire or injury may
result.
# "#' $(' ''%& "'# % #%
+$#& '# ' They may
explode.
.AA2?F6@=<@.9
@2:/92 A52 /.AA2?F <?
?2:<C2.;F 0<:=<;2;A=?<720A6;4 3?<:
A52/.AA2?FA2?:6;.9@ Fire or injury may
result. Prior to disposal, protect exposed
terminals with heavy insulating tape to
prevent shorting.
'(!#"''%&
If equipped with a lithium-ion battery, the battery
must be collected, recycled or disposed of in
an environ mentally sound manner.
“The EPA certified RBRC
Battery Recycling Seal on the
lithium-ion (Li-ion) battery
indicates Robert Bosch Tool
Corporation is voluntarily
participating in an industry
program to collect and recycle these batteries
at the end of their useful life, when taken out
of service in the United States or Canada. The
RBRC program provides a convenient
alterative to placing used Li-ion batteries into
the trash or the munici pal waste stream, which
may be illegal in your area.
Please call 1-800-8-BATTERY for information
on Li-ion battery recycling and disposal
bans/restrictions in your area, or return your
batteries to a Skil/Bosch/Dremel Service
Center for recycling. Robert Bosch Tool
Corporation’s involvement in this program is
part of our commitment to preserving our
environment and conserving our natural
resources.”
The manufacturer is not responsible for radio
interference caused by unauthorized
modifications to this equipment. Such
modifications could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful
interference, and
2) This device must accept any interference
received, including interference that may
cause undesired operation.
"#' This equipment has been tested and
found to comply with the limits for a Class B
digital devices, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. owever, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
!
WARNING
!
WARNING
.BA6<;
BM 2610027769 09-12_BM 2610027769 09-12.qxp 9/12/12 2:33 PM Page 5
