Bounce LED NOVANEON Reflex User manual
Reex
NOVANEON RANGE
NOVANEON RANGE
Novaneon Reflex is a horizontally flexible outdoor LED strip light designed
to emulate the look of traditional glass-moulded neon. Suitable for
signage/lettering applications as well as large-format architectural
installations. Its silicone-based housing is UV stable, weathertight and
highly flexible, perfect for outdoor projects.
12W/m (12V)
350 lm/m
POWER OUTPUT
LUMENS
5 Years
WARRANTY
5.0m
MAXIMUM LENGTH
IP67 (Outdoor)
IP RANK
2700K
6500K
Red
Green
Blue
Yellow
RGB
COLOUR / TEMPERATURES AVAILABLE
PROFILE
145°
AVERAGE
VIEWING ANGLE
Novaneon Reex
11
20
SALES & SUPPORT
www.bounceled.com.au
2700K / 6500K
Red / Blue / Yellow / Pink
2700K / 6500K
Red / Green / Blue / Yellow / RGB
9.0W/m (12V)
9.0W/m (12V)
12W/m (12V)
12W/m (12V)
330lm/m
330lm/m
350lm/m
350lm/m
5YR
5YR
5YR
5YR
11 x 20 mm (5m)
11 x 20 mm (5m)
11 x 20 mm (5m)
11 x 20 mm (5m)
NOVANEON RANGE
Pivot
Reex
Ø 60 mm
CURVE
CAPABILITY
41 mm
MINIMUM CUT LENTH
ACCESSORIES
SILICONE GREASE
SCRAPER TOOL
NOVANEON SHEARS
POWER CONNECTION PLUG
POWER CONNECTION SLEEVE
END CAP
ALUMININIUM MOUNTING TRACK
CLEAR MOUNTING CLIPS
To lubricate and seal end caps and connectors
To separate silicone housing from the internal strip
Cut easily and cleanly through Novanoen
Connect Novaneon strip to power. LH/RH options available
Provides Power Connection Plug
Seals the end of Novaneon length not requiring power connection.
Press fit aluminium track for external Novaneon mounting (1000mm)
Transparent installation clips
2700K / 6500K
Red / Blue / Yellow / Pink
2700K / 6500K
Red / Green / Blue / Yellow / RGB
9.0W/m (12V)
9.0W/m (12V)
12W/m (12V)
12W/m (12V)
330lm/m
330lm/m
350lm/m
350lm/m
5YR
5YR
5YR
5YR
11 x 20 mm (5m)
11 x 20 mm (5m)
11 x 20 mm (5m)
11 x 20 mm (5m)
NOVANEON RANGE
Pivot
Reex
Installation Guide
Cut material to length required using Novaneon Shears (cut only
at intervals marked on the side of the casing).
Install clear PC terminals to both ends of Novaneon to prevent
glue leaking to LED units. Trim edge of cut section with a neat 45
degree bevel to allow connectors to engage more easily.
1 2
Install End Cap
Apply 2mm of silicone glue to bottom surface of endcap before
sliding into position.
Install Power Connection Sleeve.
Slide power connection sleeve into position as indicated, take care
not to slide too far.
3 4
Install Power Connection Plug
Apply 2mm of silicone glue to bottom surface of power
connections plug before sliding into position. Separate silicone
case from PCB using provided scraper as required.
Novaneon strip can be mounted using Aluminium Track or clear
clips. When handling strip, take care to only bend horizontally and
do not twist/stretch strip as this may damage internal components.
5 6
WARNING Please read these instructions completely and carefully.
Risk of electrical shock. Disconnect power before servicing or installing product
SALES & SUPPORT
www.bounceled.com.au
PLEASE CONTACT US FOR FURTHER WARRANTY INFORMATION
www.bounceled.com.au
LED Product Warranty
LIMITED WARRANTY | Subject to change without notice
Bounce LED is committed to providing defect-free products that will give the purchaser years of trouble-free operation. All
production facilities maintain strict quality assurance standards and our products are have been designed and thoroughly
tested ensure the highest quality.
Bounce LED products are warranted to meet the performance criteria outlined in the written data sheets and specifications
and are to be free from defects in materials and workmanship for the warranty period stated. Should any LED products fail to
perform as specified during the warranty period, Bounce LED will replace all defective product in accordance with the terms
and conditions.
Modules must be installed with qualified constant voltage SMPS with international certificate to guarantee warranty.
TERMS AND CONDITIONS
This warranty is based on reasonable indoor or outdoor usage in architectural and/or signage applications for image
identification, when installed and used in accordance with instructions from Bounce LED. Normal operating conditions are
defined as 8-12 hours per day, 7 days per week, continuous use in typical outdoor heat and humidity, and environmental
conditions as stated in our product specification.
All LED systems, to varying degrees, have some amount of light degradation over the life of the product. Bounce LED designs
all of its LED systems to minimise this light degradation but considers this a normal part of LED technology.
This warranty is valid when the LED products of Bounce LED are properly installed and wired in accordance with all
instructions, building codes, the latest domestic and international safety agencies that are recognised as having applicable
safety requirements.
Any improper use in conditions that are not stated in Bounce LED’s written data sheets and instruction, or stated herein,
including the use of third party dimming, flashing or other effect devices, extreme environmental conditions or any other
unintended usage will void this warranty.
LIMITATION OF LIABILITY
Bounce LED is committed to making high quality lighting products. Returning of defective products will help us monitor and
further improve product quality. Repair or replacement of the product is the sole remedy available.
Under no circumstance shall Bounce LED be liable for any incidental or consequential loss or damage whatsoever arising out
of, or in any way related to any defect in or non-performance of the products. No warranty of merchantability or fitness for a
particular purpose is made or implied.
Furthermore, Bounce LED shall not be responsible for any other costs, including installation or field support labour or loss of
profits, income or revenue. Additionally, any drawing, layout, quotation or other communication regarding suggested product
type, amount of usage is for reference only and should be treated as an estimate.
Bounce LED shall not be responsible for minimum illumination levels or other performance criteria that is not stated in Bounce
LED’s written data sheets and instructions, or stated herein.
Bounce LED reserves the right to test and examine all products returned under this warranty to evaluate proper usage,
determine the cause of failure, and make a determination, in its sole judgement whether the products are defective and
covered by this warranty.
Table of contents
Other Bounce LED Outdoor Light manuals
