BRC NoLita User manual

NoL ta Assembly Instruction
1

1
POSITION THE FRONT AND RETURN BASE AS SHOWN BELOW, SO THAT THE
CONNECTION POINTS WILL BE IN FRONT OF EACH OTHER
FRONT BASE RETURN BASE
2
REMOVE ALL TRIMS EXCEPT FOR THE FRONT (MODESTY) TRIM.
2

3
REMOVE ALL PANELS. FIRST MOVE THEM UP, AND THEN PULL THEM BACK.
4
CONNECT THE TWO FRAMES TOGETHER USING THE HARDWARES SHOWN BELOW.
MAKE SURE THEY ARE ALLTIGHTEN WELL.
X 4 X 4 X 4
3

5
6
CONNECT THE LIFTING COLUMN WIRINGS AND POWER THEM UP.
POSITION THE LIFTING COLUMNS AT MAXIMUM HEIGHT.
4
CONNECT THE STRAIN RELIEF AROUND THE COILED CABLE. PLACE THE STRAIN
RELIEF IN THE SPECIFIED LOCATION ON THE WIRE MANAGER BRACKET. CONNECT
THE WIRE MANAGER BRACKET TO THE SPECIFIED LOCATION WITH THE PROVIDED
SELF TAPPING SCREWS. THEN SECURE THE COILED CABLE BY TIE WRAP ING IT
TO THE BOTTOM OF THE BASE THROUGH THE SPECIFIED HOLES.
THEN PUT BACK ON THE TRIMS AND PANELS.
X 2
STRAIN RELIEF
COILED CABLE
WIRE MANAGER
BRACKET

7
LEVEL THE BASE USING THE LEVELERS UNDER EACH LIFTING COLUMN.
LEVELERS
8
PLACE THE WORK SURFACES ON THE TOP FRAMES AND ALIGN THEM USING THE
PILOT HOLES. PILOT HOLES SHOULD BE ALIGNED WITH END BRACKET HOLES.
ALL WORK SURFACES ON ONE SIDE HAVE 3 PILOT HOLES AND ON THE OTHER SIDE
ONLY 2. THE SIDE THAT HAS 3 PILOT HOLES WILL ALWAYS SIT TOWARD THE
CONNECTION POINT OF THE WORK SURFACES AND THE SIDE THAT HAS 2 PILOT
HOLES SITS ON THE ENDS.
MAKE SURE THERE IS A 3/4" GAP IN BETWEEN TWO WORK SURFACES.
X 32
5

9
6
3
1
2
4
PLEASE FOLLOW SEQUENCE AS SHOWN TO CONNECT CABLES.
POWER CORD
SWITCH CABLE
MOTOR CABLE DL6
MOTOR CABLE DL6
brc.group
24 Armstrong Ave
Georgetown, ON L7G 4R9
Phone: [phone]
Toll Free: 1.877.260.4309
[email protected]
For more information contact: [email protected]