BRC Mesa Adaptive Wall Mount Electric HA Table User manual

1Align the mounting holes in the modesty brackets
with the lifting column supports and the rear wall
panel. Orient the modesty brackets as shown with
tab hooks towards the inside. The lifting column
supports and modesty brackets are universal right
and left. Attach using provided washers and bolts.
1
Preparing The Lifting Columns
Lifting column is pre-installed with M6x10 bolt.
Insert lifting column into the keyway on the
framework then lock in place from the side
by attaching with M6 screw.
2Install cantilever support with screw and
star washer to framework.
1Adjust the framework to
the distance between the bases.
Slide the assembled lifting columns and
framework in to the base attached to
the back panel.
| Mesa Adaptive Wall Mount Electric HA Table Installation Guide
2022 R1
Wall Mount Height Adjustable Mesa Assembly
This guide assumes that the wall mounting surface is level and plumb. Mounting into wood wall studs or concrete is recommended. For metal wall studs or otherwise,
sufficient support must be added to accommodate heavy loads. Contact your BRC representative for weight limit requirements and recommendations.
Preparing The Wall Panel
2Connect the lifting columns
to the bottom of the base
using screws and star
washers.
x
D Nut Inserts, 5/16"-18 x 5/8"
X8
Flat Washer 1/4" ID 9/16" OD
X8
Hex Head Bolt, 5/16"-18
X8
Flat Head Screw, M6x12
X4
Flat Head Screw, M6x12
X4
Socket Head Screw, M6x16
X8
Star Washer, M6 X8
Page 1 of 3
BRC GROUP • www.brc.group • [email protected] • 877.260.4309
Wall panel
Lifting Column
Supports
Modesty
Brackets

Place the entire assembly up against the wall
and locate as desired.
3Secure the extendable framework
tube to the specific length
with provided bolts.
2022 R1
5
6Make sure the assembled unit is level.
Adjust the levelers as needed.
7Choose wall mount hardware (not included) according to wall
material. Connect the unit to wall and make sure it’s fully
secured from all sides.
4There is a set screw on the back of each lifting column support.
Secure the leg to it’s position by tightening the set screws provided.
Button Head Screw, M6x10
X8
Page 2 of 3
BRC GROUP • www.brc.group • [email protected] • 877.260.4309
Plastic Flat-Tip Set Screws,
8-32,3/16" X2

2022 R1
Connect the two outside laminate covers using
the provided screws. There are pilot holes to
guide the installation.
8
Place the work surface on top of the framework. Use the provided wood
screws to connect the top to the frame. There are pilot holes to help with
the process. Make sure the work surface is 1” away from the wall.
11
No.10, 0.75in
Wood Screw
X10
No.10, 0.625in, Wood Screw
X8
The inner covers attach using magnets, no
fasteners are required.
9
10 Before placing modesty panel, ensure wires and wire
management is complete. Modesty panel installs by
placing panel against and above modesty brackets
and dropping down into place.
Conversly, to remove, lift up and out.
1” Required
from wall.
1”
Page 3 of 3
BRC GROUP • www.brc.group • [email protected] • 877.260.4309
Step 1
Step 2