BREEO X Series User manual

X SERIES
FIRE PIT
USER GUIDE

HOW TO BUILD
A BETTER FIRE
STEP 1
Prepare your fuel. Paper, cardboard, pine
needles, and dryer lint all make great starter
materials. You’ll also want a good supply of dry
kindling and split hardwood.
STEP 2
Build a base of starter material in the center
of your re pit. Add a layer of kindling and a
match. No need for lighter uid. Just like your
grandad did it.
STEP 3
Take things one log at a time. After the
re takes, slowly feed it more kindling. Once
you’ve got that good and going, it’s time for
your split hardwood.
STEP 4
Don’t add logs haphazardly. Building
tipi, lean-to, or log-cabin style means better
airow for your re. Remember, the blaze
needs to breathe.
STEP 5
As your re burns, keep it evenly spread
throughout the re pit.
BREEO TIP
Arranging a few embers directly
against the inner wall of your Breeo
keeps smoke at bay.

PROPER BURN
TECHNIQUES
The X Series Fire Pit is
designed for outdoor use
only. Never use your X
Series in a building, garage,
or any enclosed area.
Always place your X Series
Fire Pit on a level, reproof
surface such as rock,
stone or dirt. Never use
your X Series on wooden or
composite decks, stamped
concrete or any heat
sensitive surface.
Do not move or store your
X Series until all ashes and
coals are extinguished and
all surfaces have cooled
completely. Never touch
ashes or coals to see if
they are hot.
All surfaces of the re pit
will become extremely
hot when in use. To avoid
burns, don’t touch any
part of the re pit until it’s
completely cool (unless
you’re using protective gear
like hot pads, potholders,
etc.).
Exercise the same caution
you would with any open
re. When using your
X Series Fire Pit, never
leave it unattended,
especially around children
and pets.
The X Series utilizes a double-wall, secondary combustion
design to reduce smoke during use. When the re is
burning, the walls of the re pit heat up and hot air rises
through the gap between the two walls. The air exits the
wall cavity through the line of holes around the inside rim.
This pressurized, heated oxygen mixes with the smoke
and causes it to reburn. Use the following tips to maximize
the smoke reduction of your X Series.
!FOR YOUR SAFETY
Only burn dry, well-seasoned hardwoods such as maple, oak, hickory, cherry,
and birch. This ensures a hot, steady burn, which helps your X Series
reduce smoke. Wet, green, or soft wood (like pine or cedar) will produce
more smoke.
For maximum smoke reduction, both the bottom and side walls need to be as
hot as possible. The hotter the walls become, the more air is forced through
the rim, burning away smoke before it leaves the re pit. So, keep your re
burning as hot as possible. Keep hot coals directly against the inside wall
of the re pit. And never use a grate in the bottom of your X Series: a grate
keeps logs off the bottom of your re pit, not allowing the bottom to attain
the heat needed for smoke reduction.
At the start of your re, allow about 15 minutes for smoke to dissipate as the
re pit’s walls heat up. Adding logs to your re causes the re to temporarily
burn cooler, so add new logs one at a time to avoid an increase of smoke.
To extinguish the re, simply allow it to go out on its own if possible.
However, if extinguishing can’t wait, use a minimal amount of water to
douse the ames. Excess water sitting on the bottom of the re pit can
cause rusting, so use just enough water to put out the re.
Because of the X Airow™ technology incorporated in your X Series Fire
Pit, expect to clean out your re pit after 3–6 burns, or once the ash has
reached the holes in the X Airow™ base. Wait until your X Series Fire Pit
has cooled completely, then use a Breeo Ash Removal Tool or small
hearth shovel to scoop out the ashes.
X AIRFLOW™
Raised air vents off the
bottom of the fire pit
enables oxygen to come
in even after significant
ash build up.
DOUBLE-WALL
SECONDARY
COMBUSTION
Fire heats walls and
hot air rises through the gap
between the two walls.
The air then exits through
holes around the rim, which
mixes with the smoke
and causes it to reburn.

TENDING
TO YOUR
FIRE PIT
CORTEN FINISH
Corten is a steel alloy that looks better with
age—and without much upkeep. The Corten
nish on your X Series requires nothing more
than the occasional spot-cleaning with a dry wire
brush or damp cloth.
STAINLESS STEEL
We use grade 304 stainless steel for rugged good
looks and ultra-low maintenance. But occasionally,
you might want to clean the stainless steel
components of your X Series. We recommend your
favorite stainless steel cleaner and a soft cloth.
SEARPLATE™CARE
Cooking on your SearPlate™ for the rst time?
Be sure to give the cooking surface a once-over
with soap and water. After each use, scrub away
the worst of the mess with a wire brush or grill
scraper. Then, using a food-safe degreaser and
a scrubbing pad, clean with the grain of the
SearPlate™. Over time, your SearPlate™will build
up a natural seasoning, making it even easier to
maintain.
Every component on your new X Series Fire Pit
is built to last. You can leave your X Series out in
the elements year-round without worry and with
minimal care. But of course, the more you use your
X Series, the more ash will build up in the bottom.
From time to time, you’ll want to scoop out debris
to keep your X Series performing at its best.
And remember: always remove the ashes from
your X Series Fire Pit before long-term storage.
WWW.BREEO.CO
(800) 413 -9848
CONT[email protected]
Breeo, LLC warrants to the original purchaser that the
Breeo Fire Pits and Accessories are free from work-
manship and material defects during the lifetime of the
original purchaser. In addition Breeo, LLC warrants no
rust through or burn through for a period of ve (5) years
from purchase. If a product is covered by this limited
warranty, Breeo, LLC, at its option, will repair or replace
with a new product free of charge, excluding any applica-
ble shipping and handling charges. If the product being
warranted has been discontinued, the replacement prod-
uct will be of equal or similar value. Altering any Breeo
product, or using the product in any way other than the
intended use, will void this Lifetime Warranty. Except as
provided above, no warranty is offered on rust, paint or
nishes due to being made with material with potential
for corrosion. Steel products will develop a natural iron
oxide patina over time.
Breeo, LLC’s liability and obligation is limited to repair or
replacement of the product, at their option. The purchas-
er must provide Breeo, LLC with photos of the product’s
defects for evaluation. Upon approval of warranty, Breeo,
LLC will issue a return for repair, or return for exchange
of the defective product.
This warranty does not cover damage or product failure
caused by normal wear and tear, accident, misuse,
negligence, tampering, modications, act of war, over-
loading, improper attachment, improper maintenance,
or failure to maintain. Breeo, LLC is held harmless for
any injury or death caused by the misuse of this product.
This warranty does not cover damage caused by proper
or improper use of our products to any surrounding
surfaces, structures, or furnishings. This includes, but is
not limited to, discoloration or damage to a patio or deck
surface, furniture, house, or any other structure.
This warranty gives you specic legal rights providing
said product is put to its proper designated use.
THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER
WARRANTIES, EXPRESS OR IMPLIED, INCLUDING THE
WARRANTY OF MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE. NO ORAL AGREEMENT, GUAR-
ANTEE, PROMISE, REPRESENTATION OR WARRANTY
SHALL BE BINDING. IN NO EVENT WILL BREEO, LLC BE
LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL OR
CONSEQUENTIAL DAMAGES EVEN IF BREEO, LLC HAS
BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAG-
ES AND EVEN IF BREEO, LLC HAS KNOWLEDGE THAT
FAILURE TO PERFORM COULD CAUSE CONSEQUENTIAL
ECONOMIC LOSSES. IN ANY EVENT, CUMULATIVE DAM-
AGES FOR BREACH OF THIS WARRANTY WILL BE LIM-
ITED TO THE AMOUNT ACTUALLY PAID TO BREEO, LLC
FOR THE PRODUCT. THIS PARAGRAPH SHALL APPLY TO
ALL ACTIONS RELATED TO THE PRODUCT, WHETHER
BASED ON TORT, CONTRACT OR OTHER THEORIES. THE
PURCHASER ACKNOWLEDGES THAT THIS PARAGRAPH
ALLOCATES THE RISK OF PRODUCT FAILURE BETWEEN
BREEO, LLC AND THE PURCHASER, AND THAT THIS
ALLOCATION IS REFLECTED IN THE PRICE PAID.