Breville Paradice 16 User manual

EN INSTRUCTION BOOK FR-CA MANUEL D'INSTRUCTIONS ES-MX MANUAL DE INSTRUCCIONES
the Breville Paradice™16
BFP838

2
2 Breville recommends safety first
8 Components
11 Assembly
16 Functions
18 Tips
20 Care & Cleaning
22 Troubleshooting
Contents
BREVILLE
RECOMMENDS
SAFETY FIRST
At Breville we are very safety
conscious. We design and
manufacture consumer
products with the safety of you,
our valued customer, foremost
in mind. In addition we ask
that you exercise a degree of
care when using any electrical
appliance and adhere to the
following precautions.
IMPORTANT
SAFEGUARDS
READ ALL INSTRUCTIONS
BEFORE USE AND SAVE FOR
FUTURE REFERENCE
•Blades, cutting disk, and
dicing grids are sharp.
Handle them carefully.
•Remove and safely discard
any packaging materials
and promotional labels
before using the appliance
for the first time.
•To eliminate a choking
hazard for young children,
remove and safely discard
the protective cover fitted
to the power plug of this
appliance.
•To protect against electrical
shock, do not immerse the
power cord, power plug or
motor base in water or any
other liquid.
•Do not place the
appliance near the edge
of acountertop or table
during operation. Ensure
the surface is level, clean
and free of water.

EN
3
Vibration during
operation may cause the
appliance to move during
use.
•Do not place the
appliance on or near a hot
gas or electric burner, or
where it could touch any
other source of heat.
•Do not use on a sink.
•Always make sure
the food processor is
completely assembled
before operating. The
appliance will not
operate unless properly
assembled.
•Ensure the appliance
is switched OFF, and
unplugged from the
power outlet before
attaching any accessories,
including any blades or
disks.
•Handle the food processor
and attachments with
care. Blades, disks and
grids are razor-sharp and
should be kept out of
reach from children.
•Always secure the
processing bowl onto
the motor base before
attaching the blades or
disks.
•Do not allow the power
cord to hang over the
edge of a table or counter,
touch hot surfaces or
become knotted. Unwind
the power cord fully
before use.
•Keep hands as well as
spatulas and other utensils
away from moving blades
or disks while processing
food, to prevent the
possibility of severe
personal injury or damage
to the food processor. A
plastic spatula may be
used, but only when the
food processor isstopped.
•Ensure the appliance
motor is o and unplug
the power cord from the
outlet before removing the
lid from the processing
bowl.
•Avoid contact with
moving parts. Never push

4
food down by hand when
slicing or shredding.
Always use pusher.
•Do not fill the processing
bowl above the marked
maximum fill line for each
type of the ingredients.
Failing to follow this
instruction may cause
product malfunction,
product damage or
personal injury due to
damage to the cover
or bowl.
•Never store any blade or
disk on motor shaft.
Toreduce the risk of injury,
never place cutting blade
or disks on the shaft
without first putting bowl
properly in place. Store
blades and disks, as you
would sharp knives, out
of reach of children in the
Storage box provided.
•Be sure lid is securely
locked in place before
operating food processor.
•Never try to override or
tamper with lid interlock
mechanism.
•Always remove the plug
from the power outlet if
the appliance is not in use,
before attempting to move
the appliance, before
cleaning, disassembling,
assembling and when
storing the appliance.
•Some sti mixtures, such
as dough, may cause the
processing blade to rotate
more slowly than normal.
If this happens, do not
process for longer than
1minute.
•Do not process hot or
boiling liquids – allow to
cool to room temperature
before placing into the
processing bowl.
•Do not move appliance
while in operation.
•Do not place any part
ofthe food processor in
amicrowave oven.
•Always add drier or
thicker ingredients to the
processing bowl prior to
adding fluids.
•Never remove the lid
while the appliance is

EN
5
operating. Always use
the POWER or PAUSE
buttons to stop the
machine before
lid removal.
•Care should be taken
when removing the food
from the processing
bowl by ensuring the
motor and blade / disk
has completely stopped
before disassembling.
Ensure the POWER
button has been pressed
to switch the motor o
and unplug the power
cord from the power outlet
before removing the lid
from the processing bowl.
The processing bowl
should then be unlocked
from the motor body and
the blade / disk should be
carefully removed before
attempting to remove the
processed food.
•Do not use harsh abrasive,
caustic cleaners or oven
cleaners when cleaning
the appliance.
•Strictly follow the care
and cleaning instructions
described in this book.
To avoid possible
malfunction of bowl
switch, never store the
food processor with
pusher assembly in locked
position.
•This appliance is for
household use only.
Donot use the appliance
for anything other than
its intended purpose as
described in this book.
Donot use outdoors.
Donot use in moving
vehicles or boats.
•The use of attachments
not sold or recommended
by Breville may cause fire,
electric shock or injury.
•Do not leave the appliance
unattended when in use.
•Ensure the motor and
blade / disk have
completely stopped
before disassembling.
Ensure the POWER
button has been pressed
to switch the motor o

6
and unplug the power
cord from the power outlet
when not in use, if left
unattended and before
assembling, cleaning or
storing.
•This appliance is not
intended for use by
children or by persons
with reduced physical,
sensory, or mental
capabilities, or lack
of experience and
knowledge.
•Close supervision is
necessary when any
appliance is used near
children.
•Children should be
supervised to ensure that
they do not play with the
appliance.
•Regularly inspect the
power cord, power plug
and actual appliance
for any damage. Do
not operate if damaged
in any way or after the
appliance malfunctions.
Immediately cease use
of the appliance and visit
www.breville.com or
call Breville Consumer
Support for examination,
repair or adjustment.
•For any maintenance
other than cleaning, visit
www.breville.com or
call Breville Consumer
Support.
•If the power outlet is
astandard 2-prong wall
outlet, it is your personal
responsibility and
obligation to have it
replaced with aproperly
grounded 3-prong wall
outlet.
•Do not, under any
circumstances, cut or
remove the third (ground)
prong from the power
cord or use an adapter.
•Consult a qualified
electrician if instructions
are not completely
understood, or if doubt
exists as to whether the
appliance is properly
grounded.

EN
7
SHORT CORD
INSTRUCTIONS
Your Breville appliance
is fitted with a short
power supply cord to
reduce personal injury or
property damage resulting
from pulling, tripping or
becoming entangled with a
longer cord. If an extension
cord is used, (1) the marked
electrical rating of the
cord set or extension cord
should be at least as great
as the electrical rating of
the appliance, (2) the cord
should be arranged so
that it will not drape over
the countertop or table-top
where it can be pulled
on by children or tripped
over unintentionally and
(3) the extension cord
must include a 3-prong
grounding plug.
BREVILLE ASSIST®PLUG
Your Breville appliance
comes with a unique
Assist®Plug, conveniently
designed with a finger hole
to ease removal from the
power outlet.
For safety reasons it is
recommended you plug
your Breville appliance
directly into its own
electrical outlet on a
dedicated circuit separate
from other appliances.
If the electric circuit is
overloaded with other
appliances, your appliance
may not function properly.
FOR HOUSEHOLD USE ONLY SAVE
THESE INSTRUCTIONS

8
Components
A. Small food pusher
For improved processing control of
smaller ingredients. It also doubles as
a measuring cup. The food processor will
run continually whether the small pusher
is in or out.
B. Medium pusher
The food processor will run continually
whether the medium pusher is in or out.
C. Large food pusher
For pushing food down the feed chute.
Thefood processor will not start unless
thelarge pusher is correctly in place.
D. Extra wide 5.5 inch chute
For larger ingredients.
E. Feed chute safety system
Prevents the motor from operating unless
the bowl and lid are correctly locked in
position, and large feed pusher is inserted.
F. Processing Lid with silicone seal
Locks onto the processing bowl.
G. Mini bowl with silicone seal
H. Main bowl with handle
The bowl locks onto the motor base.
I. PLAY | PAUSE button
Press to start and pause operation of
the motor.
J. PULSE button
Press down and hold briefly for short bursts
of power. The motor will automatically stop
after the PULSE button has been released.
K. Screen display
Displays the timer.
L. POWER button
M. Count up & count down timer
Used to set desired time required for
processing. Can count up or down, stopping
the processor once the time is reached
incount down mode.
N. Powerful induction motor base
Induction motor with safety braking system.
O. Non-skid rubber feet
For added safety and stability.
A
B
C
D
E
F
G
I
J
K
H
N
O
L
M

EN
9
P. Dough Blade
Soft material blade for kneading dough.
Q. Micro-serrated S-Blade™
Swift action for chopping, mixing, and
blending avariety of ingredients.
R. Mini Processing Blade
Attach to the mini spindle and use this
blade for small quantities with the mini
bowl for chopping, mixing and blending
a variety of ingredients.
S. Adjustable Slicer
Use this disk for slicing ingredients.
Ableto slice from 1 / 8in – 5 / 16in
(0.3mm – 8.0mm) thick.
T. French Fries Cutter
Use this disk to cut ingredients into
French fry shape.
U. Reversible Shredder
Use one side of this disk for fine shredding
and the other side for coarse shredding.
V. Main Spindle
Attaches to the main bowl and drives
the Reversible shredder, the French fries
cutter or Adjustable slicer.
W. Mini Spindle.
Drives the same accessories as the Main
spindle but it is used with the Mini bowl
to process fewer quantities.
X. Storage Box
To store all accessories.
Y. Plastic Spatula
To scrape ingredients from the sides of
bowls (both the main and mini bowls).
Z. Cleaning Brush
To aid with cleaning bowls, blades, disks
and other attachments.
Box 1
P
Q
R
S
T
U
V W
X
Y
Z

10
Box 2 - The Dicing Kit:
1. 8mm Dicing Disk and Dicing Grid
2. 12mm Dicing Disk and Dicing Grid
3. 16mm Dicing Disk and Dicing Grid
4. Dicing Distributor
5. Dicing gearbox
6. 3 cleanings caps - 8mm, 12mm and 16mm
to be attached to large pusher
7. Storage Box
4
5
7
2
1
3
6