Britec LYON User manual

INSTRUCTION MANUAL
OSCILLATING WALL PATIO HEATER
Mod. LYON (WEH07)

For outdoor use only.
The manual is part of heater, it contains important information, please keep for future reference.
Dear Customer,
We congratulate you on buying this patio heater. May we insist that you read this manual thoroughly BEFORE
assembling and using this product? This manual should be kept with the heater for further reference, even if the
heater changes owner. Repair should always be done by a qualified technician. Always contact your dealer first.
Do not attempt to disable or modify this heater in any way.
WARNING
This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved. Children
shall not play with the appliance. Cleaning and user maintenance shall not be made by children without
supervision.
Children of less than 3 years should be kept away unless continuously supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has
been placed or installed in its intended normal operating position and they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved. Children
aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user
maintenance.
CAUTION — Some parts of this product can become very hot and cause burns. Particular attention has to
be given where children and vulnerable people are present.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
In order to avoid overheating, please do not cover the heater.
The heater must not be located immediately below a socket outlet.
The heater must be installed at least 1,8 m above the floor.
After fixing to a wall or ceiling direction of radiation cannot be changed without the aid of a tool.
Do not use the heater with a programmer, separate remote control system or any other device that
switches the heater automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
Its dangerous to install the heater close to curtains and other combustible materials such as curtains,
marquees, flags plastic foils etc..
Do not use the heater in reach of a shower, bath or a swimming pool.
Do not use in unventilated areas.
Do not use where gas, petrol, paint or other flammable materials are stored.
Do not push any items through, obstruct or cover the grills of the heater head.
Do not move the heater when it is connected to electrical supply.
Always wait till the heater has cooled down completely before storage.
Do not touch the heater head during in use.
Do not leave heater turned on and unattended especially when children and or animals are in the vicinity.
The heater must be placed with a clearance of 100cm to the wall and 30cm to the ceiling.

The heater is extremely hot during operation. It keeps hot for a period after shutdown. Potential danger
would occur when touching it during this period.
Do not wrap power supply cord on the unit.
The heater must be handled with care, no violent vibration or hitting.
The heater must be securely grounded during operation.
In case of damage, it must be repaired by professional electricians.
Keep the heater and its cord out of reach of children less than 8 years.
This heater is not equipped with a device to control room temperature. Do not use this heater in small
rooms when they are occupied by persons not capable of leaving the room on their own, unless constant
supervision is provided.
CAUTION: some parts of this heater can become very hot and cause burns. Particular attention has to be
given where children and vulnerable people are present.
Do not use the heater as a cloth drier or tower drier.
Do not use the heater as a sauna heater.
Do not use the heater as a room heater.
Do not use the heater in place of animal propagating and raising.
Do not immerse the heater into water for cleaning.
ASSEMBLY
When unpacking the heater, please make sure that all the items are present and there are no components left in
the box and that all the parts are free from any packing material.
Do not connect the heater to electric supply until all the assembly is done.
Do not connect the heater to electrical supply if any of the components or power cord is damaged any way. In
case of any doubt, please contact your local supplier.
A: WALL MOUNTING
Mark and drill 4 holes in the diameter of 10mm on the wall.
Insert 4 expansion bolts into the holes, then align the heater onto the bolts, lock with 4 nuts tightly.

B: ANGLE ADJUSTMENT
Loose the nuts on two sides, you can adjust the heater for desired angle. After it, please tighten the nuts.
USE
To insert the plug into a socket
Please turn on the rocker switch on heater.
Please press ON/OFF on the remote controller to use the heater. To
adjust power, please press MIN, or MAX for desired heat.
To adjust direction, please press OSC.
Please press ON/OFF bottom again on the remote controller to turn off
your heater. For a long period of inactivity, please turn off the switch on
heater and pull the plug off.
Power setting on heater allows you to turn it on/off or adjust the power manually.
Oscillating function can not be achieved via power setting.

After using the heater, it always must be turned off with rocker switch or remote controller and the power plug must
be pulled out of the socket.
Allow the heater to cool completely before moving and storage.
Never use the heater when there are bad weather conditions like rain, snow, hail, or a thunderstorm.
Pay attention that, no combustible material due to wind or other environmental influences covers or obstructs the
appliance, such as curtains, marquees, flags, plastic foil etc.
MAINTENANCE
Unplug the heater and let it cool down completely.
Keep the heater clean. The outer shell may be cleaned with soft, damp cloth. You may use a mild detergent
if necessary. After cleaning, dry the heater with a soft cloth.
Do not use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This
may cause damage or deterioration to the surface of the heater.
Do not immerse the heater in water or allow it to get wet.
Wait till the heater is completely dry before use.
Any type of maintenance or repairs including the replacement of heating tube should only be carried out by
a qualified electrician or by a recommended service center.
For a long time of inactivity, please protect the heater with a fabric cover from rain and dust.
SPECIFICATION
Power: 2000W(1000W/1000W), 50-60Hz/220-240V
Lamp: Carbon fiber
Weight: 3Kg
Item size: 630x140x300mm(LxWxD)
Cable length: 1.6m
Radiation area: 10 m2
DISPOSAL
Waste electrical production should not be disposed of with household waste. Please recycle were facilities exist.
Check with your local authority or retailer for recycling advice.