BroaMan MUX22 User manual

BroaMan Broadcast Manufactur GmbH
Alte Allee 28, 81245 München-Pasing · Germany
Phone [phone] – 60 · [email protected]
www.BroaMan.com
Quick Start Guide MUX22-IVT-series
INTRODUCTION
The MUX22-IVT/x is a pair of units providing bi-directional fiber transmission of up to 16 x
12/3G-SDI channels, 256/256 MADI or Analog/Digital Intercom connectivity, plus 4 x GPIO,
4 x LAN and SYNC
This Quick Start Guide describes all main features of the MUX-22 pair and describes how to
connect system in a few steps, using a MUX22-IVT/MADI in a 6/2 configuration as an example.
CABLE CONNECTION
A BroaMan MUX-22 set is delivered as preconfigured point-to-point set which consists of
two devices. It requires only a proper cable connection to start working with the system. After
unpacking the devices please follow the steps:
1. Connect crossed duplex singlemode fiber cable locally on each device – from Link 1 trans-
ceiver to Link 1 coupler (this connection enables integration of OPTOCORE board, which
provides intercom and data connectivity, into the COM fiber)
2. Connect crossed duplex singlemode fiber cable between two devices – from COM 1 cou-
pler on the first device to the COM 1 coupler on the second unit

BroaMan Broadcast Manufactur GmbH
Alte Allee 28, 81245 München-Pasing · Germany
Phone [phone] – 60 · [email protected]
www.BroaMan.com
Quick Start Guide MUX22-IVT-series
CONNECTIVITY
VIDEO
• BNC Ports 1-6 – 3G-SDI Inputs with reclockers (patched to outs 1-6 on the second unit)
• BNC Ports 7-8 – 3G-SDI Outputs (patched to inputs 7-8 on the second unit)
AUDIO
• 4 ports of optical MADI with SC-connectors for up to 256/256 channels of digital audio
Channels are freely routable independently of MADI streams
ETHERNET
• LAN 1-2 – 2 x RJ45 LAN ports
• SANE 1-2 – 2 x RJ45 SANE (audio over Cat5 by OPTOCORE) / LAN ports
Fiber connection between two units creates 8-port unmanaged 100Mbit Ethernet switch.
GPIO
• RS485/GPIO – 4 x GPI, 4 x GPO ports on D-SUB-15 connector
Four bi-directional GPIO ports are patched 1:1 between two Mux22 devices.
Patching can be changed in OPTOCORE Control Software.
Detailed pinout can be found in the Mux22 Operating Manual.
AUX
• AUX 1 – 1310nm fiber tunnel, not dependent on protocol or bandwidth
Aux port can be used for 1G or 10G Ethernet tunnel or any closed 3rd party protocol.
SYNC
• Sync IN – configurable Sync Input (Tri-Level-Sync, Blackburst or Word Clock)
• Sync OUT – configurable Sync Output (Tri-Level-Sync, Blackburst or Word Clock)
By default device with ID1 is the Sync Master. External Sync source should be connected to
Sync IN on ID1. Default Sync setup is Bi-Level blackburst NTSC IN and OUT. Sync Mode can be
changed in OPTOCORE Control Software.
COM
• COM 1 – fiber combined port which carries all video, intercom and data signals