Brother DCP-7080 User manual

Unpack the machine and check the components
Read the Product Safety Guide first, then read this Quick Setup Guide for the correct
installation procedure.
NOTE:
• The available connection interfaces vary depending on the model.
• The illustrations in this Quick Setup Guide are based on the MFC‑7880DN.
USB cable
We recommend using a USB 2.0 cable (Type A/B) that is no more than 2 meters long.
Network cable (DCP‑7180DN / MFC‑7880DN)
Use a straight‑through Category 5 (or greater) twisted‑pair cable for 10BASE‑T or
100BASE‑TX Fast Ethernet Network.
Remove the packing materials and install the toner cartridge
Load paper in the paper tray
Connect the power cord and turn on the machine
Configure the machine for faxing (for MFC models only)
If you do not plan to use the fax feature on this machine, go to step 5.
A
Drum Unit
(Pre‑installed)
USB Interface Cable Handset, Handset Cord and
Telephone Line Cord (For MFC models)
B
Inbox Toner
Cartridge
CD‑ROM Quick Setup Guide, Product Safety Guide
and Basic User's Guide
Connect the telephone line cord
A
B
B
A
A
B
3
4
2
1
Adjust the paper guides.
Back Front
NOTE:
• To complete fax setup on your machine, see the Basic User's Guide.
• Your machine is programmed to automatically receive faxes. To change this default mode, see the Basic User's Guide.
Remove the orange part. Remove the orange part.
Quick Setup Guide
DCP‑7080 / DCP‑7080D / DCP‑7180DN / MFC‑7380 /
MFC‑7480D / MFC‑7880DN
The latest manuals are available at the Brother
Solutions Center: solutions.brother.com/manuals.
Version 0
CHN‑ENG

Configuration using the CD‑ROM (Windows®)
Follow the on‑screen instructions
to continue installation until either
the Connect the machine or the
Connection Type screen appears.
Finish
5A
Download the full driver and software package from the Brother Solutions Center.
(For Windows®) solutions.brother.com/windows
(For Macintosh) solutions.brother.com/mac
After you download the driver and software package, follow the on‑screen instructions until either the Connect the machine or the Connection Type screen appears. Refer to
5A Configuration using the CD-ROM (Windows®).
Connection Type
For USB Connection
For Wired Network Connection
Connect a network cable first.
Follow the on‑screen
instructions to continue
installation.
NOTE:
If connection is unsuccessful, repeat this step.
Configuration without using the CD‑ROM (Windows®without CD‑ROM drive or Macintosh)
5B
NOTE:
If the Brother screen does not appear
automatically, go to Computer (My Computer).
(For Windows®8: click the (File Explorer)
icon on the taskbar, and then go to Computer.)
Double‑click the CD‑ROM icon, and then double‑
click start.exe.
Connect the machine: Follow
the on‑screen instructions to
continue installation.
Connection Type:
Finish
Connect the machine to your computer/mobile device
5
• Windows®PC with a CD‑ROM drive, go to step 5A
• Windows®PC without a CD‑ROM drive, go to step 5B
• Macintosh, go to step 5B