Brother GTX User manual

brother
STAND ASSEMBLY:
Step by Step Photo
Instructions

Step 1
•Lay back frame assembly on a flat level area.
•1st, Install smooth arm horizontal support (These
will be supports for the stand top section).
•2nd, Install a triangle bracket into the corner. Install
a washer and nut onto each of the four posts for
the triangle bracket. Note the brackets are meant
to face certain directions only.
•You may now also install washers and nuts onto
the horizontal support where it meets the back
frame.
Back frame
Smooth arm Horizontal support (TOP)
Triangle Bracket
2

Step 2
•Repeat the process from step one with on the
opposite side top horizontal support and triangle
bracket. When putting in the triangles it helps to tilt
the support arm back slightly to get the triangle
seated.
•For the bottom horizontal supports you will need to
use them in the indicated way as on picture three.
•The one support arm with the holes in an offset
position will go on the left side of the stand. These
additional holes should face upwards when the stand
is set on it’s wheels.
•You will add the arms and lock down with washers
and nuts.
Arm with holes
3

Step 3
•Mount the entire front section on the stand by lining
up the bolts with each of the support arms holes.
•Remember to install the triangle brackets here as
well for each side on the top.
•With the frame together make sure that each post
has a washer and nut. Then tighten all of them to
snug fit only. Do not overtighten or put excessive
pressure on them as this can cause a bolt to snap.
•With the frame now firm; flip the stand up and
install the waste tray on the left side of the stand.
•Lastly slide the board that came with the stand into
the support lips on the bottom section of stand
making a small table support.
4

Step 4
•To use the stand for the printer you will need at
least four people to pick up the printer and set it onto
the stand as indicated both in the quick setup manual
and here in the illustration to the right.
•Only grab the printer in areas with the arrow
markings. Note the LCD panel has one on each
side.
•When placing the printer; each of the black feet of
the printer will sit on a triangle support on the stand.
5