BTC 3MOTION R User manual

1 / 10
USER MANUAL
Podiatric Chair

2 / 10
CONTENTS
PACKING AND TRANSPORT
3
INSTALLATION
4
TECHNICAL SPECIFICATIONS
5
SYMBOLS
6
WARNINGS
7
FOOT CONTROL M3 VERSION
8
ROTATION
8
FOOT-REST
8
ARM-REST
9
IDENTIFICATION
9
CLEANING AND DISINFECTION
10
ROUTINE MAINTENANCE
10
DECLARATION OF COMPLIANCE
10
Thank you for choosing BTC products .
Before using the device, please read and keep this manual carefully: this will allow you to maintain over time the
performance, safety and reliability of the equipment.

3 / 10
Packaging and transportation
Open the box on the upper side, pull and release the chair.
Place the chair on pallets, duly directed, close to the its
final location.
The back-rest has been removed and leaning on the the
seat to facilitate shipping. Store it in a safe location to
await for the installation.
Installation
Fixing the pallet:
To separate the chair from the pallet, remove the bolt
M10 x 45 with a key 17.
Lifting points
Use grips on structural parts, such as arm and leg-joint
(see photo), avoiding grips on the casings.

4 / 10
Supply
230 V 50Hz
Operating voltage
24 V
Absorption
350W
Maximum load
210 Kg.
Maximum load on foot-rest
25 Kg
Maximum load on arm-rest
35 Kg
Maximum load on back-rest
65Kg
Weight of the chair
105 Kg
Package size
74 x 94 h90 cm

5 / 10
SYMBOLS
AC Alternate current
Class device 1 type B.
High tension (230 V)
Warning! Read this manual before the
use
Complies with 93/42/CEE
“MEDICAL DEVICES ”
BTC Srl products are manufactured in
compliance with international rules:
Restriction of Hazardous Substances
(RoHS) in electrical and electronic
equipment and the rules Waste
Electrical and Electronic Equipment
(WEEE). The symbol of the wheeled
bin and the cross above, indicating
compatibility with these standards,
and that the product can be recycled
or disposed of in compliance with
these guidelines.

6 / 10
WARNINGS
Intended Use:
The use of the podiatric chair is reserved to Chiropodists to perform outpatient operations and diseases affecting the
the foot care. The chair can not be used in the presence of flammable anaesthetic gas mixtures.
In the treatment of patients with cardiac stimulator or similar devices, the operator must intervene with the proper
precautions. In this regard refer to the specific literature in the field.
Do not exceed the loads listed in the "Specifications".
Do not remove the labels on the device.
Power supply:
Make sure that the power supply of the equipment is equipped with a circuit breaker with external differential capacity
of 16A and response threshold of 10 mA; make sure that the chair has dedicated power supply;
make sure that the mains supply is provided with adequate and efficiently earthed and that the installation of the
system complies with the current legislation
BTC disclaims any liability for any damage resulting from failure to observe the warnings and instructions in this
manual.

7 / 10
CONTROL OF THE CHAIR
The foot control allows you to store a second position, just pressing the “A” button when the chair is at position 0.
To change positions already locked, press button “A” or “B” for about 2sec. until the beep.
Descent of the chair
Ascent of the chair.
Descent of the back-rest.
Ascent of the back-rest.
Tilt of the chair.
B Button
Locked position 1
A Button
Zero position
Locked position 2

8 / 10
ROTATION
The chair can rotate for 230 ° on the horizontal
plane.
The lever "5" allows you to release or lock the
rotatation.
LEG-REST
Leg-rests are assembled on fractioned telescopic
guides, they are spread apart by 30 ° +30 ° and have
a vertical movement of 90 ° controlled by the
handles on the sides.
ARM-REST
The arm-rests can be folded down in order to aid the patient to
climb and get down from the chair, both from the front and from
the sides.
IDENTIFICATION
La poltrona è identificata dalla targa matricola collocata nella zona
indicata in figura.
Quando si richiede assistenza tecnica o si ordinano le parti di
ricambio occorre sempre indicare il numero di serie della poltrona

9 / 10
CLEANING AND DISINFECTION
For cleaning and disinfection of the external surfaces of the chair (plastic parts, paint and upholstery) use the normal disinfectants
available on the market verifying that the active substances listed are all present in the maximum concentrations indicated.
WARNING!
Do not exceed the concentrations indicated: Do not use products containing alcohol, ammonia, benzene or abrasives; spend a cloth
dampened with water on parts disinfected (even diluted disinfectants may damage the surface).
• Aldehyde Gluterica 2%: 10%
• Ethanol 96%: 40%
• Formaldehyde: 0.01%
• Glyoxal: 0.15%
• Propanol: 35%
Products must be applied using a soft cloth dampened with disinfectant: Do not spray the disinfectant directly on the equipment in
order to prevent the infiltration which could affect the functioning.
ROUTINE MAINTENANCE
The chair does not need any special maintenance.

10 / 10
Tel: [phone]
Fax: [phone]
http//www.btc-med.it
Email: [email protected]
BTC Srl
Via Altobelli Bonetti, 8/A
40026 Imola (BO)
C.F./P.I. 02489471207
R.E.A.: 443644
Capitale sociale € 180.000 I.V.
BTC Srl declares that all the medical devices
Version
Identification
from to
R
9110123-000000 9110123-999999
F
9110119-000000 9110119-999999
comply with the applicable requirements for Class 1 devices of 93/42/CEE
Imola, 15/02/2010
BTC Srl
L’amministratore