Buffalo Tools BABBS2 User manual

BABBS2 Bamboo Bar Stool Assembly & Operating Instructions
1
BABBS2
Bamboo Bar Stool Set
Max Weight Capacity 300 lbs
READ ALL INSTRUCTIONS AND WARNINGS BEFORE USING THIS PRODUCT.
STOP! DO NOT RETURN THIS PRODUCT TO THE RETAILER.
Questions? Problems? CONTACT CUSTOMER SERVICE.
If you experience a problem or need parts for this product, visit our website http://www.buffalotools.com
or call our customer help line at 1-888-287-6981, Monday-Friday, 8 AM - 4 PM Central Time. A copy
of the sales receipt is required.
Bamboo is not a wood but actually a woody variety of grass. Although it is a grass, the thick bamboo
poles are two to three times as strong as wood. However, it will fade in color and can sometimes crack.
These are the natural properties of Bamboo.
BEFORE USE, ALWAYS INSPECT THE STOOLS AND BAR UNIT FOR ANY CRACKS. DO
NOT USE IF ANY COMPONENT IS DAMAGED AND MAY CAUSE HARM.
BAMBOO SHOULD RETAIN ITS STRENGTH FOR MANY YEARS. HOWEVER, WHEN
STORED OUTDOORS, IT WILL AGE NATURALLY FROM A LIGHT TAN TO A SILVERY
GRAY. YOU MAY ALLOW IT TO AGE NATURALLY OR APPLY UV-RESISTANT
VARNISH AT LEAST ONCE A YEAR. TIES CAN BE REPLACED AS NEEDED.
When used outdoors, place on a dry surface such as concrete or decking, and not in wet areas such as
grass. Cover during inclement weather. Mild household cleaning products can be used for cleaning.

BABBS2 Bamboo Bar Stool Assembly & Operating Instructions
2
ASSEMBLY
COMMON SENSE AND CAUTION ARE FACTORS WHICH CANNOT BE BUILT INTO ANY
PRODUCT. THESE FACTORS MUST BE SUPPLIED BY THE OPERATOR.
On initial assembly, do not tighten screws completely until assembly is completed.
AFTER ASSEMBLY, CHECK THE NUTS AND BOLTS ON A REGULAR BASIS TO MAKE
SURE THEY ARE TIGHT.
PARTS DIAGRAM
Figure 7
Place the Leg Supports (#12)
between the Legs so that the post on
the support faces the hole on a
corresponding leg.
Attach Bolts at the
bottom of
each leg.
Figure 8
Place the legs so that the opening in the top of
the legs straddles the Support Beam on the
bottom side of the Seat. NOTE: Make sure the
holes on the legs face each other. When both
legs and their supports are in place
, secure the
legs to the Seat using 4 screws.
Screws
Bolts
Washer
Nut
(BABBS2 201208)