Buffalo CL205 User manual

Food Steamer
Instruction manual
Modelo: CL205
www.hosdecora.com Tel: [phone]

2
UK
Safety Tips
• Position on a flat, stable surface.
• A service agent/qualified technician should carry out installation and any repairs if required. Do not
remove any components on this product.
• Consult Local and National Standards to comply with the following:
• Health and Safety at Work Legislation
• BS EN Codes of Practice
•Fire Precautions
•IEE Wiring Regulations
• Building Regulations
• Ensure the location for the appliance can support its weight when full.
• DO NOT immerse the appliance in water.
• DO NOT leave the machine unattended during operation.
• DO NOT operate this appliance when less than one third full.
• DO NOT touch the outer surfaces of the appliance. They become hot during use.
• Suitable for indoor use only.
• Always switch off and disconnect the power supply to the appliance when not in use.
• Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of
local authorities.
• If the power cord is damaged, it must be replaced by an BUFFALO agent or a recommended qualified
technician in order to avoid a hazard.
• This appliance is not attended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or
instruction concerning the use of the applaince by a person responsible for their safety
Product Description
•CL205 - 6 litre Stainless Steel Steamer
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your BUFFALO product.
Pack Contents
The following is included:
•BUFFALOSteamerandlid
• Steamer Basket
• Instruction manual
BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.

3
UK
Operation
1. Remove the appliance from the
packaging. Make sure that all protective
plastic film and plastic coatings are
thoroughly removed from all surfaces.
2. Ensure the Temperature Control knob is
set to ‘0’.
3. Remove the lid and fill the appliance to
at least half of its capacity. Do not
exceed the Max fill line
4. Place the food to be steamed in the removable stainless steel basket
5. Replace the lid.
6. Connect to the mains power supply and turn the power switch On. The Power Indicator light
illuminates.
7. Set the Temperature Control knob to maximum to boil the water. The Heat Indicator illuminates and
the appliance heats the water.
8. When not steaming food the temperature control knob can be lowered to keep the water warm and
reduce heating times.
Thermal Cut-Out Reset
This appliance is fitted with a Thermal Cut-Out safety feature. Should the temperature exceed safe levels
the appliance will automatically cut power.
The Safety Cut-out switch resets automatically. To reset the appliance:
1. Disconnect from mains power supply, empty the appliance and allow to cool.
2. The appliance is now reset and can be used as normal.
Note: Before using for the first
time, clean the interior of the
appliance and all parts in
warm soapy water, then rinse
thoroughly.
WARNING: If the Temperature Control Knob is set to maximum then the appliance will
constantly heat the water until the power switch is turned Off or the temperature is
reduced.
Lid
Handle
Temperature
Control knob
Power Indicator light

4
UK
Telephone Helpline: 0845 146 2887 (United Kingdom)
Cleaning, Care & Maintenance
• Always turn off and disconnect the appliance from the power supply before cleaning.
• Use soapy water and a damp cloth to clean the exterior of the appliance.
•Drythoroughlyafter cleaning.
Descaling
In hard water areas lime scale can build up within the appliance after prolonged use. To descale the
appliance:
1. Pour a solution of descaler and water into the appliance.
2. Brush the interior gently with a soft bristled brush.
3. Discard the solution collected in the jug.
4. Fill the appliance with clean water and turn back On to flush out the system.
Flush out the system thoroughly to remove any descaler residue.
5. The appliance is now ready for use.
Troubleshooting
Technical Specifications
Note: Use a suitable descaler and always follow the instructions on the container.
BUFFALO recommend that this appliance is descaled every month or more frequently in
hard water areas.
Fault Probable Cause Action
The unit is not
working
The unit is not switched on Check the unit is plugged in correctly and
switched on
Plug and lead are damaged Call BUFFALO agent or qualified technician
Fuse in the plug has blown Replace the plug fuse
Power supply Check power supply
Internal wiring fault Call BUFFALO agent or qualified technician
Thermal fuse has activated Reset Thermal fuse (see page 3)
Power light
comes on but
water does not
reach
temperature
Thermostat fault Call BUFFALO agent or qualified technician
Model Voltage Power Current Capacity Weight
(full)
Dimensions
h x w d mm
CL205 230V 50Hz 1000W 4.4A 6litres 10.2kgs 305x400x335

5
UK
Electrical Wiring
This appliance is supplied with a 3 pin, moulded, BS1363 plug and lead, with a 13 amp fuse as standard.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
•Neutral wire (coloured blue) to terminal marked N
•Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Compliance
The WEEE logo on this product or its documentation indicates that the product must
not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and
environmentally safe recycling process. For further information on how to dispose of
this product correctly, contact the product supplier, or the local authority responsible
for waste disposal in your area.
BUFFALO parts have undergone strict product testing in order to comply with
regulatory standards and specifications set by international, independent, and federal
authorities.
BUFFALO products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of BUFFALO.
Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserve the right to
change specifications without notice.
www.hosdecora.com Tel: [phone]