1.562.949.8625
|
www.stronghandtools.com
|
[email protected] |
8750
Pioneer
Blvd.,
Santa
Fe
Springs,
CA
90670
U.S.A.
BUILDPRO®
Welding Tables
BuildPro®Tubing Notcher (Part No. ATN100)
USAGE INSTRUCTIONS
» How to use
1. Mount the fixed base(A) of the fully assembled BuildPro®Notcher on the BuildPro®Tabletop, using four pieces of
BuildPro®Ball Lock Bolts, Part No. T55015. [NOT. Incl.] or Socket Shoulder Screws, Part No. T831612. [NOT. Incl.]
2. Insert the Cutter Bar(D) through the open channel of the Rotating Support Block(C). Install the Hole Saw.
3. Adjust the placement of the two V-Blocks(E) and the Clamp(G) as required for the desired notch angle. Set the desired
height and angle using the Vertical Height Adjustment Knob(B) and Rotating Support Block w/ Angle Scale(C).
» Applications
OPTIONAL
T55015 OPTIONAL
T831612
Ø .625” x 2” pitch; compatible with: BuildPro®,
Rhino Cart®and FixturePoint™ Welding Tables.
45º Compound Angles90º Reference Angles
Visit StrongHandTools.com for info on the standard BuildPro®components used in these setups.
(Shown with
BuildPro®Plate)
Hole Saw [Thread Sizes: 1/2"-20,
5/8"-18.] NOT INCLUDED.
Safety
ALWAYS wear safety goggles, gloves, and other appropriate safety
items for protection. Use the notcher only for it’s intended purpose.
Do not drop the notcher, throw it, or otherwise misuse the notcher.
Limited 1 Year Warranty
Each STRONG HAND TOOLS® product is warranted to be free
from defects in material and workmanship. Return to place of
purchase for a replacement if warranty applies.
