Bush DWFS125W Assembly Instructions

DWFS125W
Installation & User Instructions

5-11
5-7
8
9
9
9
10
11
12-19
12-14
12
13
14
15-17
18
19
20
20
21
21
22
23
24
Adjusting the tension of the door spring
Aesthetic panel installation
Specification
2-3
4

button
button
LED display
DWFS 12 5W

Hop Hook

7

Adjusting the tension of the door spring
The door of the dishwasher is attached to springs. These are set at the factory to ensure that they are at the proper tension,
so that the door can open and close smoothly.
After the furniture door has been fitted, you will need to adjust the tension of the door spring.
Fully open the appliance door to allow access to the adjusting screws.
Using a 4mm Allen key, rotate the adjusting screw which are located on the front top corners of the appliance, to either
tighten or slacken the steel cable.
The doors spring tension is correct when
a) The door remains horizontal when in the fully opened position.
b) You are able to shut the door easily, by raising the door using your fingers.
WARNING: If you do not adjust the tension of the door spring, then it could cause damage to the appliance.
Top right tension
adjusting screw
8

50
9
2
and the adjustable lever

10

11

1
2
2kg
500ml
2
12

13

14

appliance
15

appliance
WARNING!
Do not let any item
extend through bottom
!
16

appliance
17

Hot rinse
Hot rinse
Hot rinse
Hot rinse
Standard daily cycle
for normally soiled loads,
such as pots, plates, glasses.
18

Continue to press “program” button until the desire washing program is selected. During pressing
the “program” button, the indicator light will switch from “intensive” to “Pre-wash” and then get
back to “intensive” as a cycle. Once the desired washing program is selected, close the door and
the machine will start to operate.
Special attention :
If all the indicator lights start to glimmer, the machine should be out of order. Please turn off the power
and shut down the water supply. Then call the customer helpline.
Program End
1.When the washing program is finished, it will sound 6 times and displays ''--''.
2. Open the door and remove all the dishes.
3.Turn off the unit by pressing the ON/OFF switch. Then close the door.
4. Shut down the water supply after using.
Warning :
It is dangerous and not recommend to open the door during the washing operation. The hot water may
come out and scald you while the door is open during the operation.
The unit will produce a click sound when the door is closed properly. When the washing is finished,
you can switch it off by pressing the ON/OFF button once.
If you open the door when washing, the machine pauses and sounds warning alarm, it displays E1.
Under different status, the program indicator will light in different combination:
button.
Open the door, to change the program, press the ON/OFF switch once to turn off. Once it is off, press
the ON/OFF button again to turn it on. Continue to press the " program" to select desire washing
program. Then close the door and the machine will start to operate with new washing program.
19