Bush DWFS147SS Assembly Instructions

258/8324

5-11
5-7
8
9
9
9
10
11
12-20
12-14
12-13
14
15
16-18
19
20
21
21
22
22
23
24
25
Adjusting the tension of the door spring
Aesthetic panel installation
Specification
DWFS147SS
2-3
4

255/8324
10
9
W
10 Drain pipe connector
9 Inlet pipe connector

Hop Hook

7
Note:The consideration strip is not included.

Adjusting the tension of the door spring
The door of the dishwasher is attached to springs. These are set at the factory to ensure that they are at the proper tension,
so that the door can open and close smoothly.
After the furniture door has been fitted, you will need to adjust the tension of the door spring.
Fully open the appliance door to allow access to the adjusting screws.
Using a 4mm Allen key, rotate the adjusting screw which are located on the front top corners of the appliance, to either
tighten or slacken the steel cable.
The doors spring tension is correct when
a) The door remains horizontal when in the fully opened position.
b) You are able to shut the door easily, by raising the door using your fingers.
WARNING: If you do not adjust the tension of the door spring, then it could cause damage to the appliance.
Top right tension
adjusting screw
8

50
9

10

11

1
2
2kg
2
12

The unit is equipped with a function that you
can adjust the frequency to release the salt to
the water softener. This is further to the
selector on the salt container. The default
setting is H4.
IMPORTANT :
YOU SHOULD SET THIS VALUE
ACCORDING TO THE WATER HARDNESS
ST
OF YOUR AREA BEFORE THE 1 USE.
INCORRECT SETTING WILL AFFECT THE
RESULT OF THE WASHING. ONCE YOU
HAVE SET THE SETTING, THE UNIT WILL
REMEMBER THE LAST SETTING.
Adjustment for value
1. Find out the hardness value for your tap
water or your area.
2. Compare with the table below to find out the
required value for setting to this unit.
Table
Frequency to
release salt
Value for
selecting in
this unit
Never
Always
Seldom
Often
Often
Sometimes
Sometimes
Usually
3. Close the door
4. Press ON/OFF button to turn on the
machine
5. Press Delay button and Program button at
the same time and hold for 5 seconds. The
machine will sound once. It displays H4.You
can release both buttons.
6. Continue to press Delay button to select the
desire value, i.e. H5, H6 or H7 is for serious
water hardness area region like UK.
7. Once the desire value is selected, press
Program button to confirm. Then the setting
has been stored and it will get back to the
normal standby status.
Hint : For easy setting on this value, it is
suggested to select H7. Then you can control
the salt consumption by turning the selector
on the salt container.
13

14

15

appliance

appliance
WARNING!
Do not let any item
extend through bottom
!
Cutlery tray
Cutlery should be placed in the cutlery tray as
shown in diagram. They should be placed in
different area zone to ensure the water runs
off freely.
17

appliance
18

Standard daily cycle
for normally soiled loads,
such as pots, plates, glasses.
19