CONEKT BENCH
ASSEMBLY GUIDE FOR CONEKT BENCH
12
34
56
7 8
~
1. Screw the eight threaded metal rod pieces clockwise into the matching holes in the leg
sections.
2. Insert the eight wooden dowels into the matching holes in the leg sections.
3. Connect the leg sections to the seat. Please make sure not to scratch the seat when facing
upside down by placing a blanket underneath.
4. Place the brackets in all four corners, making sure that the brackets with the sunken holes
are placed on the outside.
5. Attach the washer and nut to the threaded metal rod. Quick tip – it can be easier to mount
the nut if the leg sections are left with a gap of approx. 10mm to the end of the seat.
6. Use the spanner to tighten the nut by turning it clockwise. Make sure all eight nuts are
tightened evenly.
7. Insert the screws into the pre-drilled holes and tighten them by turning them clockwise.
8. Finally add felt pads and well done.
approx. 10 mm
x20
x4 x6
x6
x1
x6
x6
x2
x1
x4
washers
nuts
spanner
metal
rods
wooden
dowels
leg
sections
screws tabletop
inner
brackets
x8
x8
x1
x8
x8
x2
x1
outer
brackets
x1
hexagon spanner
x8
cross-thread
bolts
x4
x20
x4
x4
x4 x4
felt pads
