Byer of Maine Pangean Glider User manual

Pangean Glider Assembly Instructions
Important Note:
We are a Maine based company and deeply commited to supporting you with this assembly.
PLEASE give us a call if we can help in any way. As you assemble, be sure NOT to fully tighten the
fasteners until you have inserted the last of 14 screws. This provides exibility and eases assembly.
Contact us for any help:
Byer of Maine
74 Mill St. Orono, ME 04473 USA
Phone: [phone]
Email: [e-mail]
www.byerofmaine.com
Step 2
Assemble lower narrow crossrail
and install 2 screws loosely tightened
One screw,
each end
Step 1
Set the two frame assemblies side
by side with rounded parts up. Assemble
TOP (Short) crossrail and install 4 screws
loosely tightened
install with wider
groove UP
Two Screws,
each end

Step 3
Stand frame upright with legs on oor and pull open toward you as illustrated below:
Step 4
Assemble tapered cross rail w/logo
facing up & loosely tighten 4 screws:
Step 5 Assemble (long) sloed cross-
rail with wide side of groove facing up. Fasten
with 4 screws. You now can tighten all 14
screws you have used in the assembly:
Step 6 Assemble the cover the the frame
Thread cover up through top crossrail, insert dowel and seat in groove. Lift cover
over crossrail and thread other end over and up through lower crossrail. Note it may be
easies to follow the images A, B & C below
C
B
A
Two Screws,
each end
Two Screws,
each end
Logo facing up