Byiba 2414B User manual

mm
*
Art.
80
80
465 x 255
465 x 170
2415B
2414B
*
+
+
-
-
= 12,5 mm
= 25 mm
12
345
6 7 89
Terminal block is not included. For the installation
qualified personnel may be required. (we recommend
CABIT V3S 2P / STEAB 5590)
2414B
2415B
IP 20
GU10
MAX 35W
240V
MADE IN ITALY
025.550(REV02)

IMPORTANT
To ensure equipment safety you must carefully follow the instructions below. This leaflet must be kept handy by personnel entrusted with all ordinary and
extraordinary maintenance.
• Before any installation or maintenance operation on the bulb, make sure it is disconnected from power.
• Fit the correct bulbs, according to the type and power indicated on the lamp data label.
• Make sure the lamp technical features are compatible with the use you are going to make of it.
• Should you have any doubt, refer to the dealer or ask an electrician.
• When connecting to the mains, fallow the correct colour code far power cables: (N) blue, (L) brown or black and, only far class I equipment, (T) yellow/green.
• When lamps are to be fitted to the wall directly through their ceramic parts, fasten the fixing screws lightly, to avoid breaking the ceramic.
• To clean the lamp on the outside, use a soft cloth, possibly wet. Do not use solvents or abrasive products. No liquid must get in contact with the lamp interior
parts.
• Do not touch the equipment with dirty hands.
= Class I equipment, must be connected to an earth terminal.
= Double insulated lamp, does not need earthing.
= Electrical equipment in class III, electrical safety guaranteed by low voltage tension, does not require grounding
= Replace immediately the safety glass, if damaged, with the original part.
= Minimum distance to be observed from all lit up objects.
= The lamp uses low pressure bulbs, and needs no protection glass.
= Device with CE marking
= The equipment at the end of its life must be collected separately from other waste