BYRNE interport User manual

2. Place template in desired position on the work surface. Check to be sure there are no support braces or
drawers below this area. Drill first 1/8" pilot hole, insert a 1/8" pin (a #8 nail works well) in the hole so the
template does not move and drill second pilot hole. Draw a line around the outside of the temp late and remove.
3. Drill (2) 3/8” (.375) diameter holes in the pilot holes. Cut along the lines with a saber saw.
1. Install data jacks as described in the installation instructions provided with Voice/Data Adapter Kit,
BE01421. Wire the data jacks per the manufacturer's instructions.
Tools: Electric Drill, 1/8" (.125 Dia.) & 3/8” (.375 Dia) drill bit, saber saw, rasp.
4. Use the finger holes to slide the template through the hole. Be sure to keep the template horizontal. If
there is any interference, use a rasp to remove the interference.
Sheet 1 of 2
IS01539
320 Byrne Industrial Dr.,
2005 Byrne Electrical Specialists, Inc. All Rights Reserved.
Rockford, Michigan 49341 Fax [phone]
Phone [phone]
B Y R N E
I N S T A L L A T I O N I N S T R U C T I O N S F O R T H E B Y R N E I N T E R P O R T
12/08/05
5. Insert Interport into cutout. Use phillips head screwdriver to tighten locking cams snugly to the work
surface. Do not overtighten.

IS01539
320 Byrne Industrial Dr.,
2005 Byrne Electrical Specialists, Inc. All Rights Reserved.
Rockford, Michigan 49341 Fax [phone]
Phone [phone]
Opening Size
Note: Drawing not to scale
"X" Dim.
6.00
18.00
12.00
Ganging
Triple Interport
Double Interport
Single Interport
4.50
Sheet 2 of 2
12/08/05
R .190
(4) Places
6. Place the cord holder approximately 12” from the Interport using the double faced tape included.
“X” Cutout Edge