BYRNE MINI-PORT User manual

B Y R N E
Sheet 1 of 2
IS01573
Phone [phone]
320 Byrne Industrial Dr., Rockford, Michigan 49341 Fax [phone]
12/08/05
I N S T A L L A T I O N I N S T R U C T I O N S F O R T H E B Y R N E M I N I - P O R T
2005 Byrne Electrical Specialists, Inc. All Rights Reserved.
2. Place template in desired position on the work surface. Check to be sure there are no support braces or
drawers below this area. Drill first 1/8" pilot hole, insert a 1/8" pin (a #8 nail works well) in the hole so the
template does not move and drill second pilot hole. Draw a line around the outside of the temp late and remove.
3. Drill (2) 3/8” (.375) diameter holes in the pilot holes. Cut along the lines with a saber saw.
1. Install data jacks as described in the installation instructions provided with Voice/Data Adapter Kit,
BE01421. Wire the data jacks per the manufacturer's instructions.
Tools: Electric Drill, 1/8" (.125 Dia.) & 3/8” (.375 Dia) drill bit, saber saw, rasp.
4. Use the finger holes to slide the template through the hole. Be sure to keep the template horizontal. If
there is any interference, use a rasp to remove the interference.
5. Insert Mini-Port into cutout. Use phillips head screwdriver to tighten locking cams snugly to the work
surface. Do not overtighten.

IS01573
320 Byrne Industrial Dr.,
2005 Byrne Electrical Specialists, Inc. All Rights Reserved.
Rockford, Michigan 49341 Fax [phone]
Phone [phone]
Opening Size
Note: Drawing not to scale
Sheet 2 of 2
.375 Dia. (4) Places
Area to be removed
from worksurface
2.25 Centerline to centerline
of drilled holes
2.47 Cutout Edge
5.81Centerline
to centerline
of drilled holes
6.03
Cutout Edge
12/08/05
2.46
R .190
(4) Places
Note: Depending on the combination of coupler/jack/cord installed, it may be desirable to loosely secure the
data cord to the Mini-Port latch with a tywrap to prevent potential interference.
6. Place the cord holder approximately 12” from the Mini-Port using the double faced tape included.
"X" Dim.
6.00
18.00
12.00
Ganging
Triple Mini-Port
Double Mini-Port
Single Mini-Port
“X” Cutout Edge