C-Tech Manufacturing CopBox User manual

7.Thread nut insert on to hex bolt – tooling compression
nut assembly. Nut insert ange should contact
machined lip on tooling compression nut.
8.Nut insert should be thread completely on to hex bolt /
tooling compression nut assembly.
9.Insert nut insert / tooling compression nut / hex bolt
assembly into pre-drilled hole in wall.
10.Using open end wrenches or ratchet socket, hold
tooling compression nut with open end wrench and
tighten the hex bolt to compress nut insert.
11.Do not over tighten nut insert. Nut insert should be
compressed to hold in wall.
12.Unthread hex bolt and tooling compression nut from
installed nut insert.
13.Use hex bolt and
tooling compression
nut for installation
of remaining nut
inserts.
TACTICAL
Dodge Durango
INSTALLATION GUIDE
7501 Commerce Dr
Weston, WI 54476
715.355.8842
WE BUILD IT BETTER
6.Slide hex tooling compression nut on to hex bolt 1/4
– 20 X 1-1/2” zinc. Make sure tooling compression nut
raised machined lip is away from hex bold head
NUT INSERT INSTALLATION STEPS:

1. Remove rear sill plate, rear oor panels, and
luggage D Rings.
(not pictured)
2. Install rear mount bracket, using original
factory mounting hardware.
3. Remove factory clip from storage container
in oor and replace with supplied nut insert.
Please see nut insert procedure for installation
instructions. (mount panel will not be installed
at this point)
4. Install front mounting bracket with supplied
hardward into the nut inserts and Mopar sup-
plied hardware for the 4 seat studs towards the
passenger compartment.
5. Connect gas shock assist to the rear mount-
ing bracket ball studs. Shaft end of gas shock
should be towards the rear bracket.
6. Set CopBox Cabinet into vehicle and slide
QuickLink front lip on the CopBox Cabinet into
the Z Rail on the front bracket.
6. Attach gas shocks to bottom ball studs on
the CopBox Cabinet.
6. Set CopBox Cabinet down and insert CTech
knobs to secure rear of CopBox Cabinet.
DURANGO INSTALLATION STEPS: