C3 C3P23LJ-2087DO User manual

Operating Instructions
C3P23LJ-2087DO
7215960100R00
www.c3furnishings.com
! NOTE: The heater on
your fireplace may emit a
slight, harmless odor when
first used. This odor is a
normal condition caused
by initial heating of internal
heater parts and will not
occur again.
CUTOFF SWITCH
! NOTE: There is a safety
temperature cutoff switch
(cutout) inside the heater.
If the heater overheats,
the cutout will shut off the
supply power.
It can be reset by
unplugging the unit and
waiting 5 minutes before
plugging the unit back on.
CAUTION: If you need
to continuously reset the
heater, unplug the unit and
call technical service at
1-888-346-7539
Power ON/OFF
The ON/OFF button turns the fireplace ON and OFF. When the
fireplace is OFF, power indicator icon is lit red. Power icon turns
green when power is ON.
The fireplace has a built-in memory function, when turned back on,
it starts at the last used settings except for the timer. If the fireplace
insert is disconnected from the main power source, it reverts to the
default settings.
! NOTE: Each time the fireplace insert is plugged in, it runs an internal
program check and the heater will turn on for 5 seconds.
The fireplace can be operated with the multi–function IR remote
control or from the control buttons located on the top-right corner of
the fireplace.
The remote control has an operating range of up to 5.8m / 19ft.
1. Power ON/OFF
2. Mode Button
3. Up/Down Buttons
4. Indicator Icons
5. Digital Display
Remote
154
3
2

Mode Button
Press the Mode Button to cycle through Heat,
Timer or Flame Brightness set mode.
Heat Set Mode
When active press Up or Down Button to set
temperature from 59°F (15°C) to 86°F (30°C),
ON and OF. ‘ON’ means the heater operates
continuously. ‘OF’ (OFF) means only the fan will
operate the heater will be off.
! NOTE: When the heat is turned off, the heating
element will shut down first then the fan after
20 seconds.
Changing the Temperature Unit (°F °C):
Press and hold the Mode Button on the
fireplace for 3 seconds to change the displayed
temperature units.
! NOTE: This function cannot be set with the
remote control.
Timer Set Mode
When timer mode is activated 0.0 appears on
the display and the timer indcator light is lit
yellow. Press Up/Down Button to set the sleep
timer by scrolling through the following:
0.0 (off), 0.5 (30 min), 1.0 (1h), 1.5, 2.0, 2.5 ...9.0.
The fireplace shuts off after the selected time
period. Switching the fireplace off with the
Power Button clears any timer setting.
Flame Brightness Set Mode
When set in this mode, use the Up and Down
Buttons to select from the available 6 options:
F0 (no flames), F1, F2, F3, F4 and F5 (the
brightest flames and ember bed).
UP/DOWN Buttons
These buttons are used to adjust heater, timer
and flame settings.
Child Lock Enable & Disable:
When the fireplace is ON, press and hold the
Power ON/OFF Button on the fireplace for 10
seconds. Three beeps and flashing ‘E3’ indicate
that the Child Lock function is activated. The
Mode, Up or Down buttons will not operate and
‘E3’ will be displayed when pressed. The power
ON/OFF button will also not operate, but only
beeps will indicate that the child lock has been
activated.
To disable the Child Lock, again press and hold
the Power ON/OFF Button for 10 seconds.
! NOTE: This function can only be done through
the fireplace controls, not using the remote
control.