CABINETCO Modern Gray Series User manual

Assmbly Instruction
Drawer Base
This assembly instruction is for reference only. Page 1
Required Tools:
Power Drill
Rubber Hammer
Step-by-Step Instruction:
Step 1
Step 2
Lay back panel (C) flat,
grooves facing upward
Insert Side panel (A) on (C)
and secure with metal clips
(Refer to Metal clip system
above)
Slide bottom panel (D) into
grooves of (A) and (C)
Code
Description
Qty.
A
Side Panel (L/R)
2
B
Face Frame
1
C
Back Panel
1
D
Bottom Panel
1
E
Toe Kick
1
F
Drawer Box (Side/bottom panels)
3 sets
G
Drawer Face
3
H
Sliders & Adapter
3 sets
I
Plastic Slider holder
6
J
Support Bracket (wooden)
4
For Product lines:
Modern Gray/Frenso Gray Shaker/Anaheim
Gray/Beech Espresso/Cinnamon Shaker

Assmbly Instruction
Drawer Base
This assembly instruction is for reference only. Page 2
Step 3
Step 4
Attach Front frame (B) onto
(A)
(Referal to metal clip
system above)
Attach Toe kick (E) onto
bottom front of (A)
(Referal to metal clip
system above)
Step 5
Step 6
Screw both rear slider
holder brackets (I) into pre-
drill holes in C, angle facing
upward
Install sliders (K) into L and
screw into the side of B
Assemble the drawer box by
using Rubber Hammer
*Use wood glue for a
permanent bond*
(Beech espresso drawer box
using screw assembly)
Step 7
Step 8
Attach plastic adapter
underneath the drawer(s)
There will be a letter
indicating L or R side
Position Drawer box(s) F
over drawer sliders K

Assmbly Instruction
Drawer Base
This assembly instruction is for reference only. Page 3
Step 9
Attach Drawer face (G) onto
drawer front
Place Wooden support
brackets (J) into corners of
A, B, C