Calspas THE CHILL SPA User manual
1
LTR20231170
9/23/2023
www.calspas.com
1
LTR2031170
9/23/2023
SINCE 1978
THE CHILL SPA
PLATINUM™SERIES
2023
Owner’s Manual
QUICK START GUIDEQUICK START GUIDE
LTR#117000937
2
LTR20231170
9/23/2023
www.calspas.com
3
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY!
When using installing and using this spa, basic safety precautions should always be followed, including:
1. DANGER: RISK OF SEVERE INJURY OR DROWNING!
• DO NOT allow children to be in or around a spa unless a responsible adult supervises them.
• Keep the spa cover on and locked when not in use.
• See instructions enclosed with your cover for locking procedures.
2. DANGER: RISK OF SEVERE INJURY OR DROWNING!
• The suction ttings in this spa are sized to match the specic water ow created by the pump. Should the
need arise to replace the suction ttings, or the pump be sure the ow rates are compatibl1e.
• Never operate the spa if the suction tting or lter baskets are broken or missing. Never replace a suction
tting with one that is rated less than the ow rate marked on the original suction tting.
3. DANGER: RISK OF SEVERE INJURY FROM ELECTRIC SHOCK OR DEATH FROM ELECTROCUTION!
• Install the spa at least 5 feet (1.5 meters) from all metal surfaces. As an alternative, a spa may be installed
within 5 feet (1.5 meters) of metal surfaces if each metal surface is permanently bonded by a minimum #8
AWG solid copper conductor to the outside of the spa’s control box.
• DO NOT permit any external electrical appliances, such as lights, telephones, radios, televisions, and etc.,
within 5 feet (1.5 meters) of the spa. Never attempt to operate any electrical device from inside the spa.
• Replace a damaged power cord immediately.
• DO NOT bury the power cord.
• Connect to a grounded, grounding-type receptacle only.
4. WARNING: RISK OF HYPERTHERMIA (OVER-HEATING) CAUSING SEVERE INJURY, BURNS, WELTS
OR DEATH!
• Water temperature in excess of 104°F (40°C) may be injurious to your health.
• The spa water should never exceed 104°F (40°(). Water temperatures between l00°F (38°C) and 104° F (40°C)
are considered safe for a healthy adult.
• Lower water temperatures are recommended for young children and when spa use exceeds 10 minutes.
• Before using the spa, the user should measure the water temperature since the tolerance of water tempera-
ture-regulating devices varies.
5. WARNING: TO REDUCE RISK OF INJURY
• Prolonged exposure to hot air or water can induce hyperthermia. Hyperthermia occurs when the internal
temperature of the body reaches a level between 3°F (2°C) to 6°F (4°C) above the normal body temperature
of 98.6°F (37°C). While hyperthermia has many health benets, it is important not to allow you body’s core
temperature to rise above 103°F(39.5°C).
• High water temperatures have a high potential for causing fetal damage during pregnancy. Women who
are pregnant, or think they are pregnant should always check with their physician prior to spa usage.
• The use of alcohol, drugs or medication before or during spa use may lead to unconsciousness, with the
possibility of drowning.
3
LTR20231170
9/23/2023
www.calspas.com
4
7.
8.
9.
10.
11.
12.
Do notpermita ny electricappliance, suchas a light,t elephone, radio,or television
within 5 feet(1.5 m) of a spa.
5.5 Hypothermia
Hypothermia occurs when the body’s temperature drops
below 95˚ F (35˚ C).
Signs of mild hypothermia (95˚ F to 89.6˚ F // 35˚ C to 32˚ C ) include:
Shivering and chattering teeth
Exhaustion
Clumsiness, slow movements and reactions; prone to falling
Sleepiness
Weak pulse
Fast heart rate (tachycardia)
Rapid breathing (tachypnea)
Pale skin color
Confusion and poor judgment/loss of awareness
6 Proper Ventilation: Proper ventilation of Chill Spa necessary for optimal operation.
The Chill Spa uses a water chiller which will generate warm exhaust air from the cooling of the Chill Spa. The
Chill Spa is designed for outdoor use, for proper airow allow up to 3’ - 5’ feet of space around the unit
without obstructions. DO NOT OBSTRUCT THE EXHUAST VENTS, blocking these vents will be dentrimental
to the operation of the Chill Spa, with higher energy consuption and slower cooling speeds.
Never install the unit in a closed room with a limited air volume in which the exhaust air expelled from
the unit will be reused, or close to shrubbery that could block the air inlet. Suchlocations impair the
continuous supply of fresh air, resulting in reduced eciency and possibly preventing sucient
cooling/heating output.
DO NOT USE THE CHILL SPA FOR
EXTENDED PERIODS OF TIME
Extended use of the chill spa in
tempertures bellow 60F can increase
your risk of hypothermia.
Contact medical services if
symptoms of hypothermia arise.
Call 911 in a medical emergency.
4
LTR20231170
9/23/2023
www.calspas.com
5
□
□
□
4
□
□
□
5
LTR20231170
9/23/2023
www.calspas.com
6
Chill Spa Quick Start Guide
1. Remove Filter Skimmer.
Remove the Skimmer from the lter housing by gently pulling
upward, this must be reinstalled after the spa has been filled up
and primed. ENSURE THE SPA POWER IS OFF DURING DRAIN
AND DURING REFILL.
2. Remove The Filter .
Once the skimmer is removed, the lter can be removed by
holding the lter by the tab, turning counter-clockwise. Once
the lter is removed, soak the lter in water for about 15 minutes
before reinstallation.
3. Filling the Chill Spa.
Preventing airpockets in the plumbing is essential, for this reason
insert the hose through the lter canister to prevent air pockets
from forming. failure to do so can cause damage to the
refrigeration system.
NOTE: Never ll your spa with soft water.
Soft water makes it impossible to maintain the proper water
chemistry and may cause the water to foam, which will ultimately
harm the nish of the spa and void your warranty.
You may ll your ll your spa with well water provided the fol-
lowing conditions are met: Have a Total Dissolved Solids (TDS)
and metals test performed by a qualied person after the ll-up
process but before any spa use
6
LTR20231170
9/23/2023
www.calspas.com
7
Chill Spa Quick Start Guide
4. Water level
Fill the spa up to 4’’ from the rim of the spa. Once the Chill Spa is lled
reinstall the lter clockwise. DO NOT OVER TORQUE/TIGHTEN this can
damage the damage the lter housing over time. once the lter is back
in its place you can slide the skimmer back onto the lter housing. the
skimmer slides into the hilter housing with two sliding tabs on the top of
the skimmer.
The water level will shift once a person enters the Chill Spa, adjust your
water level based on the shift of the waterline once the unit is being
used.
5. Connect the Chill Spa to power.
Using the supplied 15 amp GFCI plug, connect it to the outlet running
from the dedicated 15 amp circuit. Once connected press the“jets”
button to prime the internal pump.
6. Programing the Cooling unit.
Begin by using the main spa controls and hold the button for 2
seconds and the temperture will appear on the display. once it does you
may let go of that button and press the cool button to lower the spa
to 39 F, once that is done press the“Set” button to save the desired
temperture. Additional programing may be needed.
Refer to page 25 if after one hour has passed and the temperture has not
lowered.
7. Open Air Vents.
Once water is circulating, press the switch on the left hand side of the
Chill spa to open and close the air vent. When the air vents are opened
this allows more pressure to exit the jets for a deeper massage. this will
assist in clearing the plumbing of any air pockets.
Note: The Chill Spa has several paths for condensation to exit. A
small pool of water forming on the base of the spa is considered
normal. The amount of condensation varies based on the weather
and ambient humidity.
7
LTR20231170
9/23/2023
www.calspas.com
9
Setting Temperature and Time
This Chill Spa is equipped with a SmarTouch Control System.
SmarTouch Digital comes to you with a universal set of default settings. If you choose to keep these set-
tings, then you only need to remember 2 things: how to set the spa temperature and to press the SET key
whenever you are done using the spa.
WIRING DIAGRAM FOR SC-1100 (JR.)
WIRING DIAGRAM FOR SC-3000
IN A HURRY - READ THIS
SmarTouch Digital comes to you with a universal set of default
settings. If you choose to keep these settings, then you only
need to remember 2 things: how to set the spa temperature and
to press the SET key whenever you are done using the spa.
Setting Temperature
The UP(TEMP) & DOWN(TIME) arrows.
Press and hold for 2 sec. the UP (TEMP) arrow key.
Controller will display current spa temperature.
Use the UP or DOWN arrow keys to select
desired temperature.
*To enter new temperature press → SET key.
The controller will:
- Lock-in the new temperature.
- Display current spa temperature.
IMPORTANT: Always turn down the heat before you drain the spa.
*Note:
Both buttons are used to select, increase
or decrease temperature or time setting.
Note: Both keys are active when pressed
individually and held down 2 seconds, to
eliminate accidental changes.
Page 23
If no buttons asre pressed the screen will reset within 30 seconds the
controller reverts to the previous setting and the change will not take
effect.
The SET Key
After using the spa, press the SET key to tell the micro controller you
are done using the spa. It will then take over the spa’s management,
including the different filtration cycles, heat maintenance, economy
modes and protection against freezing.
Page 4
8
LTR20231170
9/23/2023
www.calspas.com
10
Setting Temperature and Time
SETTING TIME-OF-DAY
Setting Time-Of-Day
Press and hold for 2 sec. the DOWN (Time) arrow key.
Controller will display 12:00 noon. Use OR to set the
correct time-of-day.
*After every selection “Hours , Minutes” press
→
SET key.
Cool-Down Timer
A 30-second timer keeps the low speed jets, ON, after the heater turns
OFF, to remove all residual heat from the heater element.
User Timer
A built-in, 20 minutes elapsed-time clock switches off any active function.
Economy mode. Water & Energy Management.
The Economy mode manages water temperature, filtration and energy
consumption knowing “when” to heat to maintain water temperature.
The Economy mode starts when the heater is turned off and the spa is
not in use.
Upon entering the ECONOMY mode the message “ECON” is displayed.
During the Economy mode the spa controller is in stand-by, three hours
at a time, monitoring and sampling the water temperature.
At the end of every Economy period which is 3 hours the controller ac-
tivates the low jets only for 5 minutes to perform the following:
1-Filter and sanitize the water. Check your spa manual for the type of
sanitizer in your spa.
2- Stabilize the water temperature and heat if necessary, in that case the
low jets run more than 5 minutes for the duration of the heating cycle.
Important: Tie down your spa cover to minimize heat loss and to con-
serve energy.
Note: The message “ECON” is not an error code.
WIRING DIAGRAM FOR SMTD 1000
WIRING DIAGRAM FOR SMTD 2000
COM2
J14
Page 5 Page 22
9
NOTES
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
10
NOTES
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
11
NOTES
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
12
LTR20231170
9/23/2023
www.calspas.com
33
SINCE 1978
262-23
Contact Information
For customer service, please contact your
authorized dealer immediatly. Aditional information
or additional assistance contact.
LMS Customer Service Department
1462 East Ninth Street
Pomona CA, 91766
Toll Free: 1-800-CAL-SPAS
Fax: 1-909-629-3890
Table of contents
Other Calspas Hot Tub manuals
Calspas
Calspas Ultimate Fitness Hot Tub User manual
Calspas
Calspas PATIO User manual
Calspas
Calspas SWIM PRO SPAS User manual
Calspas
Calspas Rejuvenation Series User manual
Calspas
Calspas Spa Wrap User manual
Calspas
Calspas F-1325 User manual
Calspas
Calspas Home Resorts Escape Series User manual
Calspas
Calspas Swim-Pro F-1641 User manual
Calspas
Calspas Patio Series User manual
Calspas
Calspas F-168 User manual
Calspas
Calspas patio plus User manual
Calspas
Calspas SWIM User manual
Calspas
Calspas LES User manual
Calspas
Calspas LTR20111002 User manual
Calspas
Calspas Villa Spa Home Resort User manual
Calspas
Calspas Home Resorts FA-1325 User manual
Calspas
Calspas 6115 User manual
Calspas
Calspas F-1222 User manual
Calspas
Calspas LTR20121002 User manual
Calspas
Calspas LTR20111058 User manual
Popular Hot Tub manuals by other brands
Jacuzzi
Jacuzzi J-485 owner's manual
Jacuzzi
Jacuzzi SWIM SPA Series installation guide
QCA Spas
QCA Spas Paradise Series owner's manual
Aquatic
Aquatic iNfiNity serIes Owner's manual & installation guide
Aquatic
Aquatic Hotsoak 71 AI9AIR7444HS Specification sheet
BainUltra
BainUltra NOKORI installation instructions
