Campania International FT-52 User manual

F
T
-
52
Long
meadow
Fountain
Two people are recommended for the installation ofthisfountain!
R
evised
July21, 2017
-WINTERCARE-
Fountainbowls/topsandotherfountaincomponents,whichcollect water, shouldnotbeleftoutsideinthewinter since anycomponent,
whichfillswithwater andfreezesmaycrack.Likewise, componentssuchaspedestals,whichremaininabasin,filledwithwater,
whichthenfreezes,mayalsocrackor crumble. Ideally, therefore, afountainshouldalwaysbestoredindoorsor inadryprotected
place suchasacoveredporchawayfromtheelements. However, ifafountainmustbeleftoutside:
(1) Removepump, rubber stoppers, drainpipes, finials,andother smallcomponentsfor storageindoors. Note that stoppersor
drainpipesareremovedtoallowdrainageintheeventwater accumulatesinanybasin.
(2) Raisefountainbasefromgroundwithwood stripssothat basewill notfreeze tothegroundsurface.
(3) Cover or wrapthefountainwithburlapor other absorbentmaterial (oldblanket or towel) andthencover securelywith
plastic,making surethat water will notaccumulate inthebasinor other fountaincomponentandfreeze;
(4) Checkfountainperiodicallytoinsurethat plastic issecureandwater isnotaccumulating inanyfountaincomponent.
-GENERALFOUNTAINTIPS-
Install fountainsonalevel surface. Youwill needaproperlygrounded110-volt (AConly) GFCI protectedreceptaclenear the
fountainfor your pump. All pumpsaresubmersible andmustbecompletelyunderwater tofunctionproperly. Testall pumpsand
adjusttofull outputprior toassembly. Itisnotrecommendedthat fountainsbeplaceddirectlyongrass or dirt. Positionthechannel
opening at thebaseofeachfountaintoward theelectrical outlet tobeusedsince thepump
cord willbethreadedthroughthisopening.
CheckoutYouTubefor a“Howto”video.
For moreCampania product informationvisit www.campaniainternational.com
All of ourcaststone is proudly
Pump KitPartsList
PK140 pump (1)
#7 stopper(1)
Approx.8”length of1/2”BlackNon-kinktubing (1)
Approx.4”length of1”i.d. PVCpipe (1)
Wedges(2)
Hose clamps(3)
*Hoseclamps maybe used asflow restrictors
FOUNTAININFORMATION:
Thisfountain holdsapproximately3gallonsof water.
Thisfountain usesasmallfountain cover.
(FTNCOV-SM)
Norefill device orsubmersible lightsare suggested for
thisfountain
TOOLSREQUIRED:
Bubble Level
PUMPINFORMATION:
OEMPF140 - 140GPH Pump
6FTcord length

F
T
-
52
Long
meadow
Fountain
Two people are recommended for the installation ofthisfountain!
R
evised
July21, 2017
Assemble yourfountain on a levelsurface capable ofholdinga minimumof243 poundswith an approximate1 square
footfootprint.
FT-52C (132lbs)
13”Lx13”Wx27”H
FT-52B (81lbs)
24”Wx9”H
FT-52A(4lbs)
7”Wx3”H
1. Placethe base (FT-52C)into position wherethe fountain will be installed,
ensuringthatit islevel.
2. Placethe 4” length ofPVCpipe into the holein the topofthe base(FT-
52C).
3. Centerthe bowl (FT-52B)overthe PVCpipe inthe base (FT-52C).
4. Assemble the pump kit
a. Usinga hoseclamp, attach the 1/2” non-kinktubingtothe pump
outlet.
b. Placea hose clamp overtheotherendofthe 1/2"non-kinktubing
c. Placethe stopperaround the pump cord approximately6” fromthe
pump.
5. Feed the pump cordthrough the holeinthe bowl(FT-52B)and thechannel
in the base(FT-52C).
6. FIRMLY press the stopperintothe hole evenly.
a. Note:Usingthehandle ofascrewdriverorhammerworksbestto
pressthe stopperin place.
7. Placethe otherend ofthe 1/2” non-kinktubingontothe copperpipe
protrudingfromthe bottomofthe waterfeature(FT-52A)and tightenthe
hose clamp.
8. Lowerthe waterfeature(FT-52A)into the bowl(FT-52B).
a. Turn the feature tocoilthe tubingasyou loweritintoposition.
9. Fillthe fountain with water.