WARNING: Follow all instructions to prevent serious injury or product damage. Do not
attempt to remove, modify, or repair parts or damaged parts.
Product installed by a qualified professional. Can-Dan is not liable for injury or damage
caused by improper mounting.
●Use indicated dimensions to mount changing table.
●Please protect wall panel components from dust during installation.
●Apply and post labels, stickers and instructions near or on table
Electrical Connections Ensure that all power components are connected securely. Connect
control box either by means of an approved moisture-resistant wall box or by leading an
approved cable through the wall for connection outside the room. Use a standard single gang
flush mount outlet box. See the drawing for proper location of the outlet box. The wall outlet
power supply is 120v 15 amp. Use GFI as required. The GFI control can be located at the
wall panel or outlet. The product includes a built-in 24v/1amp transformer, 8’ power cord and
3-prong wall plug.
Secure all cords/cables to protect users from tripping.
Important!
Attention Product Owner / Installer:
Before using your newly installed Pressalit changing table, carefully inspect and ensure that
•All fasteners and anchors are tight.
•The hand control wall bracket is installed (recommend right side of the wall panel).
•The safety rail operates correctly.
•Move the product to its highest and lowest levels to confirm that there are no
obstructions (e.g., the power cord) in the wall panel.
(Refer to the user manual for inspection intervals, operation and cleaning procedures)
Troubleshooting
Should you experience any difficulty, verify the correct current, check the power and hand
control plugs at the control box, making sure they are firmly connected. Check the operation
manual for further troubleshooting tips.
Please contact Can-Dan for any assistance or questions.
Subject to change without further notice
