Canaan CL-802 User manual

REF Illustration Description QTY
ASeat 1
BSeat supports 2
C 10-1.50mm x 75mm
bolts
washers
4
4
DWedge Anchors 4
Compotents
Assembly Instruction CL-802/702

1. Assemble the seat
supports(B) and the
seat (A) with bolts and
washers (C).
Insert bolts (C) loosely.
2. Fasten all the bolts.
Assembly
Tools Required
Long arm hex key, wrench, and linesman plier.
Recommendations
* To protect the powdercoating nish during assmebly, please place unwrapped powdercoated parts on
non-marring surface. Please do not place parts on cement or other hard surface. If damage on nish
occurs, please use touch-up paint to avoid rust in future.
* Insert screws and install hex nuts with washers and tighten carefully to avoid damaging nish.
Assembly Instruction CL-802/702

Instruction for Surface Installation
CANAAN INC.
1. Drill the proper size and depth hole.
at the holes are too large can usually be detected earliest when the wedge anchors moves
forward by more than a fraction of an inch (1/4” max) during tightening.
2. Clean all the dust out of the hole with a blower or similar tool.
3. Hammer the expansion bolt into the hole.
Gently tap the wedge anchors until it is at the bottom of the drilled hole.
Two or three solid blows to compact the lead.
4. Tighten the nuts rmly.
Make sure the nut has not been over tightened; otherwise you can cause unnecessary stress on
the wedge anchors and cause it to break.
Instruction for Surface Installation