C&T International Sorelle Modesto User manual

Made in Thailand
Important Information:
Read all instructions
By Sorelle - A Division of C & T International, Inc.
46 Whelan Road, East Rutherford, N.J.07073 U.S.A.
Tel, 201-531-1919 Fax, 201- 531-1920
BEFORE assembling crib.
KEEP INSTRUTIONS FOR FUTURE USE.
Modesto/Monterey flat top crib
Assembly Instruction
Website: www.sorellefurniture.com

Page 2
WARNING
*Infants can suffocate on soft bedding. Never add a pillow or comforter. Never place additional padding
under an infant.
*Failure to follow these warnings and the assembly instructions could result in serious injury or death.
DO NOT use this crib if you cannot exactly follow the accompanying instructions.
*To reduce the risk of SIDS, pediatricians recommend healthy infants be placed on their backs to
sleep, unless otherwise advised by your physician.
*Strangulation Hazard: STRINGS CAN CAUSE STRANGULATION! Do not place items with a string
around a child's neck, such as hood strings or pacifier cords. Do not suspend strings over a crib or
attach strings to toys.
*Strangulation Hazard: To help prevent strangulation tighten all fasteners. A child can trap parts of
the body or clothing on loose fasteners.
*Strangulation Hazard: Do not place crib near window or patio door where cords from blinds or
drapes may strangle a child.
*Fall Hazard: When child is able to pull to a standing position, set mattress to lowest position and
remove bumper pads, large toys and other objects that could serve as steps for climbing out. This crib
has an adjustable mattress support. For the convenience of the parent when the baby is very small, the
mattress support may be used in the highest position.
*Fall Hazard: Stop using crib when child begins to climb out or reaches a height of 35in. (89cm),
whichever occurs first. The child should be placed in a youth or regular bed.
*Check this product for damaged hardware, loose joints, loose bolts or other fasteners, missing parts,
or sharp edges before and after assembly and frequently during use. Securely tighten loose bolts and
other fasteners. Do not use crib if any parts are missing, damaged or broken.Contact C&T
International Inc./Sorelle for replacement parts and instructional literature if needed. Do not substitute
parts.
*Follow warnings on all products in a crib.
*If refinishing, use a non-toxic finish specified for children's products.
*Never use plastic shipping bags or other plastic film as mattress covers because they can cause
suffocation.
*Infants can suffocate in gaps between crib sides and a mattress that is too small.
*Ensure a safe environment for the child by checking regularly, before placing the child in the crib, that
every component is properly and securely in place.
*To avoid head injury, do not allow any child to play underneath the crib.
*Never add an accessory such as a bassinet or changing table that extends over the sleeping area.
C
Crib Warnings
AUTION : ANYMATTRESSUSEDINTHISCRIBSHALL
BEATLEAST271/4”(69CM)x515/8”(131CM) WITH
ATHICKNESSNOTEXCEEDING6”(15CM).
SORELLE

Page 3
Sorelle
C
AU
RIBMUST
BEA CM) WITH
ATHI
NOTES ON ASSEMBLY:
-During the assembly process whenever using screws or bolts, check each by placing the screw/bolt on
the diagram of the item which is drawn actual size and design. Be sure to use the proper size and shape
specified in the instructions.
-To assemble this unit you may be required to place the unit on it’s side and face. It is strongly
recommended that assembly is done on a soft, non-abrasive surface to avoid damaging the finish.
NOTES ON CARE AND MAINTENANCE:
- Do not scratch or chip the finish.
- Inspect the product periodically, contact C&T International Inc. for replacement parts or questions.
- Do not store the product or any parts in extreme temperatures and conditions such as a hot attic or a
damp, cold basement. These extremes can cause a loss of structural integrity.
-To preserve the luster of the high quality finish on your product, it is recommended to place a doily or
felt pad under any items you place on the finish.
-Clean with a damp cloth, then a dry cloth to preserve the original luster and beauty of this fine finish.
-Do not use abrasive chemicals.
-Do not spray cleaners directly onto furniture.
-Lift slightly when moving on carpeting to prevent leg breakage.
-Use of a vaporizer near furniture will cause wood to swell and finish to peel.
NOTES ON USE:
Keep children and others safe by following these simple rules:
- Do not allow any child to play on furniture
- Do not allow climbing on any piece of furniture.
- Do not allow hanging from any piece of furniture.
- Always monitor your child’s activity when in the nursery.

Page 4
Important: In order to properly assemble the crib, carry out the operations in order specified. Failure to assemble the crib in the manner recommended could
make the crib hazardous.
SORELLE
(B) Right End
(D) Mattress Support Bar
(C) Foot Board
(A) Left End
(1 pcs)
(1 pcs)
)scp1(
( 1 pcs)
(E) Mattress Support
(F) Left Back Post
( 1 pcs)
(G) Right Back Post
( 1 pcs)
(J) Crib Top Back Rail
( 1 pcs)
(H) Headboard Panel
( 1 pcs)
(1 pcs)
Figure 1
Step 1
Use 4 pcs Bolt (b) with 4 pcs Half moon washer(d) and 2pcs Wooden dowel (e)
attach Bottom Back Rail (K) to Left Back Post and Right Back post (G&F).
As shown in Figure 1.
(a) M6 x 20 mm Bolts ( 4 pcs)
(b) M6 x 70 mm Bolts ( 10 pcs)
(c) M6 x 45 mm Bolts ( 12 pcs)
(h) Barrel Nut (4 pcs)
(d) Half moon washer (6 pcs)
( j ) Allen Key (1 pc)
(e) Wooden dowel (2 pcs)
( f ) Washer ( 16 pcs)
( g ) LockWasher ( 16 pcs)
A
B
H
J
F
G
E
C
D
G
F
H
d
e
b
j
H
F
X 4

Page 5
Step 3
Attach (J) Headboard Top Rail to Left Headboard Post (F) and Right Headboard Post (G) to using
(2 pcs) Bolts with 2 pcs Half moon washer(d) as shown.
SORELLE
Use 6 pcs Bolts (c) with 6 pcs Washers(f) & 6pcs Lock Washers (g) to attach
Left End(A) & Right End(B) to Headboard.
Attach the Mattress Support Bar (D) Use 4 pcs Bolts (b) with 4 pcs Washers(f) & 4pcs
Lock Washers (g) and 4 pcs Barrel Nut (h) to Left End(A) & Right End(B) .
Step 2
Figure 3
Figure 2
d
b
j
H
J
J
F
H
X 6
F
A
D
A
B
H
f
c
g
X 2
h
h
f
b
g
f
b
gD
A
X 2

Page 6
Figure 5
SORELLE
Use 6 pcs Bolt (c) & 6 pcs Washers(f) & 6 pcs Lock Washers(g)
attach Foot Board(C) to Left End (A) & the Right End (B).
As shown in Figure 5.
Step 5
Step 4
Attach the Mattress Support Use 4 pcs Bolts (a) with
4pcs Lock Washers (g)to attach Left End(A) and Right End (B)
Figure 4
Crib Assembly
2
1
a
g
3
X 4
Center Level
2
Lower Level
Higher Level
1
3
E
B
A
B
E
A
A
A
A
C
X 6
c
f
g

Page 7
SORELLE
FINALLY CHECK
• PRIOR TO USING THE CRIB, ENSURE ALL BOLTS ARE TIGHTENED. DO NOT OVER TIGHTEN.
• ENSURE THAT THE MATTRESS IS THE RECOMMENDED SIZE.
• ENSURE THE MATTRESS BASE IS LOCATED AT THE CORRECT LEVEL TO SUIT THE CHILD.
• CRIB IS NOW READY FOR USE.
TODDLER BED and FULL SIZE BED ASSEMBLY ( Option Purchase )
Disassembling Crib for Storage
To disassemble crib for storage, follow assembly steps in reverse.
Store all parts and hardware together in a safe place. Store the instruction manual in the supplied
envelope attached to mattress support base for future reference for reassembly.
To clean, use only mild household soap and warm water.DO NOT use bleach or detergent. DO
NOT use abrasive cleaners which can scratch the finish. Use clean soft cloths to wash, rinse and
dry.With proper care, the quality finish will last a long time.Wood surfaces may be treated with
a light application of a good grade of non-toxic furniture polish. Read contents on back of polish
to make sure polish will not harm unit.
Store all parts from Crib, which are not used for Full Size Headboard, in original carton(s) (if
available) to prevent damage and allow reuse.
Cleaning and Storage
Note: The Toddler rail (#136) and Adult rail (#215) are sold separately to convert
the crib to a Toddler bed and a full size bed for your choose.
Contactthe store where you purchased the crib or
visit www.sorellefurniture.com to locate a dealer near you