Canon imageRUNNER 1750iF Safety guide

Starter Guide
Installation Space Requirements
Items Included with the Machine
Unpack the Machine
Install the Filters
Attach the Duplex Tray and the Tray Rib
Install the Drum Unit
Install the Toner Cartridge
Load Paper in the Paper Drawer
Attach the Precaution Label
Connect the Power Cord
This guide explains the procedures from unpacking
the machine through power cord connection.
Be sure to read the manual before using the
machine. The remarks for important safety
instructions are described in “User’s Guide.” Read the
manual also.
Keep the manual for future reference.

ii
01
CONTENTS
01 Installation Space Requirements
02 Items Included with the Machine
03 Unpack the Machine
06 Install the Filters
07 Attach the Duplex Tray and the Tray Rib
08 Install the Drum Unit
12 Install the Toner Cartridge
14 Load Paper in the Paper Drawer
16 Attach the Precaution Label
17 Connect the Power Cord
Indicates a caution concerning operations that may lead to injury to persons if not
performed correctly. To use the machine safely, always pay attention to these
cautions.
Indicates operational requirements and restrictions. Be sure to read these items
carefully to operate the machine correctly, and avoid damage to the machine or
property.
Symbols Used in This Manual
The following symbols are used in this manual to explain procedures, restrictions, handling precautions, and
instructions that should be observed for safety.
Indicates an operation that must not be performed. Read these items carefully, and
make sure not to perform the described operations.

ii
01
To ensure proper ventilation and easy operation, set up the machine in an area that meets the
minimum requirements for clearance, as illustrated below.
View from Above
(When the optional Staple Finisher-H1 is attached.)
*The width is 37 1/8" (941 mm) when no options are attached.
Installation Space Requirements
37 3/4" (960 mm)
21 1/4" (540 mm)
50 1/4" (1,276 mm)*
4" (100 mm)

02
03
In the next section “Unpack the Machine,” check each item against this list as you remove it from the
accessories box (except for the drum unit).
Power Cord
Drum Unit Paper Size Labels
CD-ROM × 5*3
Registration Card
Paper Manual × 3
Filters*1Duplex Tray Tray Rib
Precaution Labels
*1 These lters are not supplied with the imageRUNNER 1730iF/1730.
*2 Only for the imageRUNNER 1750iF/1740iF/1730iF. For instructions on how to connect the cable, see Chapter 2,“Before You Start Using
the Machine,” in the User’s Guide.
*3 The number of CD-ROMs may vary depending on the models you purchased.
Items Included with the Machine
Telephone Line Cable*2

02
03
0301
04
Pull out the paper drawer as far as it will go
and then remove the tape and the packing
material inside.
Lift the paper drawer and pull it out
completely.
02
Press the button on the paper drawer.
Remove the materials shown in blue and set
aside the machine’s accessories box on the
right side for later use.
Unpack the Machine
For Users with the Optional Cassette:
Go to the installation manual supplied with the
optional cassette to attach the cassette to the
machine, then continue from step 7 under “Unpack
the Machine”in this document.

04 Unpack the Machine Unpack the Machine 05
05
The machine weighs about 97.7 lb (44.3 kg).
Use two or more persons to lift the machine
and move it to the installation site.
Be sure to rmly hold the front of the
machine by the paper drawer slot and lifting
handles on the rear side of the machine.
Holding other than the specied parts
may result in damage to the machine
and/or personal injury.
Be careful not to slip on the
polyethylene bag for the
machine.
If you have a back problem, make sure to
check the weight of this machine before
lifting.
97.7
lb
44.3
kg

04 Unpack the Machine Unpack the Machine 05
07
08
06
Gently push the paper drawer back into the
machine until it clicks into place.
Remove all shipping tape from the ap side
edges.
Lift the feeder, remove the protective sheet,
and take out the drum unit.
Be careful not to get your ngers caught, as this
may result in personal injury.

06
07
Install the lters on the right side of the
machine.
01
For the imageRUNNER 1730iF/1730, the following steps are not necessary. Go to the next section,
“Attach the Duplex Tray and the Tray Rib.”
Install the Filters

06
07
If you are attaching the optional Staple Finisher-H1 to the machine, the following steps are not
necessary. Go to the next section, “Install the Drum Unit.”
Lift the control panel.
01
Attach the duplex tray by inserting its tabs
into the slots on the machine.
02
Insert the front tabs of the tray rib into the
slots rst and then press down on its left
end so that the rear tabs snap into the slots.
03
Lower the control panel back in place.
04
Attach the Duplex Tray
and the Tray Rib
Be careful not to accidentally insert the tabs into the slot
circled in the illustration.

08 Install the Drum Unit 09
Remove the waste toner container.
04
Open the front cover.
01
Open the right cover.
Always open the right cover during installation to prevent
damage to the drum unit.
02
Turn the toner container lock lever
counterclockwise 90 degrees.
Toner Container Lock Lever
03
Install the Drum Unit