Canon Easydive Leo3 User manual

Easydive - Via dell’Industria 13 int 6, 48015 Cervia (RA) - Italy [e-mail] - [phone] | [phone]
EOS R
Hand Control - Right
Front Back
1. Autofocus (Exposure Reading) and Shutter Release Mode. To change the
shooting mode, hold down Button 1 until the Red LED is switched on (15 sec.). In
Video Mode becomes the af-on.
2. Photo Shoot:
Mode 1: When you press the button you have the autofocus, when you release
the button you will have the shoot (Default Setting).
Mode 2: When you press the button first you have the autofocus and then the
shoot. (If the lens is already in focus you will have the direct shoot).
In Video Mode becomes REC.
Buttons 4,5,6,7 Change function depending in which Mode is setted the Camera.
Aperture - Priority (Av):
4. Aperture -
5. Aperture +
6. EV -
7. EV +
Shutter - Priority (Tv):
4. EV -
5. EV +
6. Shutter Speed -
7. Shutter Speed +
Manual Mode (M):
4. Aperture -
5. Aperture +
6. Shutter Speed -
7. Shutter Speed +
Right Hand Control
8. ISO
9. ISO
10. On / Off electronic board (to switch on press once, to switch off hold down
about 3 seconds until the board is switched off). The camera will go in Standby
limiting the power consumption. To activate the Camera, after switch on the
electronic card, press the Button 2.
3. Change Mode (M/Av/Tv/P). Insert the camera in mode M.
+
-
Press the buttons 4,5,6,7,8,9 once to change by one step. Keep pressed to
quickly change the chosen parameter.

Easydive - Via dell’Industria 13 int 6, 48015 Cervia (RA) - Italy [e-mail] - [phone] | [phone]
EOS R
Hand Control - Left
Back Front
Left Hand Control
1. Displacement of the focus point, you can move the point in the center of the nine
square of the grid.
2. x5 x10 zoom of focus area point.
3. Change Autofocus Mode.
4. Video Mode activation. To return to Photo mode, press the button 4 again.
5. Change Preset White Balance.
6. Change Photo or video quality.
7. On / Off servo (video) or continuous af (photo).
10. On / Off electronic board (to switch on press once, to switch off hold down
about 3 seconds until the board is switched off). The camera will go in Standby
limiting the power consumption. To activate the Camera, after switch on the
electronic card, press the Button 2.
9. Change Drive Mode.
8. Change Metering Mode (Matrix Center-Averange-Spot). In WB Custom this button
acquire the WB in Manual.