•Replacing the Battery
When
the
effective
range
decreases
replace
the
battery.
Use
one
button
lithium
cell
battery
CR2032.
1.
Press
the
catch
on
the
left
side
of
the
battery
holder
inwards
CD
as
you
pull
the
battery
holder
out
®.
(Fig.2)
2.
Load
a
new
battery
into
the
holder
with
the
+
and
-
terminals
correctly
positioned
and
then
push
the
holder
back
into
the
remote
control.
(Fig.3)
•
Remove
any
dirt
or
fingerprints
from
the
battery
before
inserting.
Failure
to
do
this
may
cause
corrosion
or
malfunction.
•
Be
sure
to
read
the
precautions
included
with
the
battery.
•
Keep
the
batteries
out
of
reach
of
children.
If
swallowed,
contact
a
physician
immediately.
•Specifications
Type:
Channel mode:
Transmission:
Operating range:
Battery:
Battery life:
Dimensions
(W
xHx
D):
Weight:
Consists
of
infrared controller,
signal transmitter and signal
sensor
in
the camera body
Two-second delay release
By
transmit button
Approx. 5m/16.4
ft.
One button lithium cell battery
CR2032
Approx. 6,000 transmissions
64
x
34
x6
mm
2.5 x1.3 x0.2
in.
8.1
g/0.28 oz (without battery)
2
•All
data
is
based
on
Canon's
Standard
Test
Method.
•
Subject
to
change
without
notice.
This device complies with Part
15
of the
FCC
Rules.
Operation
is
subject to the following two conditions:
(1)
This
device may not cause harmful interference, and
(2)
this
device must accept any interference received, including
interference that may cause undesired operation.
Do
not make any changes or modifications
to
the equipment
unless otherwise specified
in
the instructions.
If
such
changes or modifications should
be
made,
you
could
be
required
to
stop operation of the equipment.
This equipment has been tested and found
to
comply with
the limits for aclass Bdigital device, pursuant
to
part 15 of
the
FCC
Rules. These limits are designed
to
provide
reasonable protection against harmful interference
in
a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and,
if
not installed and
used
in
accordance with the instructions, may cause harmful
interference
to
radio communications. However, there is no
guarantee that interference will not occur
in
aparticular
installation.
If
this equipment does cause harmful
interference
to
radio or television reception, which can
be
determined
by
turning the equipment off and
on,
the user is
encouraged
to
try to correct the interference
by
one or more
of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between
the
equipment and
receiver.
•Consult the dealer or
an
experienced radiofTV technician
for help.
This digital apparatus does not exceed the Class Blimits for
radio noise emissions from digital apparatus as set out
in
the interference-causing equipment standard entitled ·'Digital
Apparatus", ICES-003 of the Industry Canada.
For
CA,
USA
only
Included lithium battery contains Perchlorate Material -
special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate/ for
details.
CE:
The
C(
Mark is aDirective conformity mark of
the
European Community (EC)
La
marque C( est une marque conforme aux
directives
de
la
Communaute Europeenne
Das
C(
-Zeichen entspricht den EG-Richtlinien
La
marca C( es una marca directriz
de
conformidad
de
la Comunidad Europea (CE)
