Canon imageFORMULA DR-3080C User manual

Version 2 DR-3080CII VPAT: Updated 09/21/2006
Voluntary Product Accessibility Template (VPAT)
Name of Product: DR-3080CII
Date: September 21, 2006
Note: This document was prepared based on normal walk-up functionality. It does not include maintenance and
troubleshooting procedures. The information contained in this document is proprietary information and is not
for reproduction, publication or manipulation in any way or form. This template addresses a multitude of
Canon DR-3080CII features; however, any specific inquiries should be made to the Canon Government Marketing
Representative.
The rules below refer to the Electronic and Information Technology Accessibility Standards (covered by Section
508 of the Rehabilitation Act of 1998) issued by the Architectural and Transportation Compliance Board. Comments
in the “Supporting Features” column are based on the Information Technology Industry Council’s suggested
language for use when filling out the Voluntary Product Accessibility Template. The Remarks and Explanations
column provides additional information on the evaluation results, and explains the standard functions of the Canon
DR-3080CII that can accommodate users with disabilities.
Summary Table
Voluntary Product Accessibility Template
Criteria Supporting Features Remarks and
explanations
Section 1194.21 Software Applications and
Operating Systems Not determined. Software not evaluated.
Section 1194.22 Web-based internet
information and applications Not applicable.
Section 1194.23 Telecommunications
Products Not applicable.
Section 1194.24 Video and Multi-media
Products Not applicable.
Section 1194.25Self-Contained, Closed
Products Supports with exceptions.*
Section 1194.26 Desktop and Portable
Computers Not applicable.
Section 1194.31 Functional Performance
Criteria Supports with exceptions.*
Section 1194.41 Information,
documentation and Support Supports with exception.*
* Please refer to the following pages for detailed information on supporting features and exceptions.
1

Version 2 DR-3080CII VPAT: Updated 09/21/2006
Section 1194.25 Self-Contained, Closed Products - Detail
Voluntary Product Accessibility Template
Criteria Supporting Features Remarks and explanations
(a) Self contained products shall be usable by
p
eople with disabilities without requiring an
end-user to attach Assistive Technology to the
p
roduct. Personal headsets for private listening
are not Assistive Technology.
Does not support. Assistive Technology is
required for users who are
blind.
(b) When a timed response is required, the
user shall be alerted and given sufficient time
to indicate more time is required. Supports. There is no function to
require timed response.
(c) Where a product utilizes touchscreens or
contact-sensitive controls, an input method
shall be provided that complies with Section
1194.23 (k) (1) through (4).
Not applicable. This product does not
utilize touchscreens or
contact-sensitive controls..
(d) When biometric forms of user
identification or control are used, an
alternative form of identification or activation,
which does not require the user to possess
p
articular biological characteristics, shall also
be provided.
Not applicable.. User authentication by a
biometrical method is not
used.
k)(1) Products which have mechanically
operated controls or keys shall comply with
the following: Controls and Keys shall be
tactilely discernible without activating the
controls or keys.
Supports.
There is only a power
switch on the machine
which is tactilely
discernible without
activating it.
(k)(2) Products which have mechanically
operated controls or keys shall comply with
the following: Controls and Keys shall be
operable with one hand and shall not require
tight grasping, pinching, twisting of the wrist.
The force required to activate controls and
keys shall be 5 lbs. (22.2N) maximum.
Supports.
Operations do not require
tight grasping, pinching or
twisting of the wrist.
Controls and keys do not
require a force of more than
5 lbs.
(k)(3) Products which have mechanically
operated controls or keys shall comply with
the following: If key repeat is supported, the
delay before repeat shall be adjustable to at
least 2 seconds. Key repeat rate shall be
adjustable to 2 seconds per character.
Supports..
There is no key repeat.
(k)(4) Products which have mechanically
operated controls or keys shall comply with
the following: The status of all locking or
toggle controls or keys shall be visually
discernible, and discernible either through
touch or sound.
Not applicable. There is no locking or
toggle controls or keys.
(e) When products provide auditory output,
the audio signal shall be provided at a standard Not applicable. There is no sound output terminal.
2

Version 2 DR-3080CII VPAT: Updated 09/21/2006
signal level through an industry standard
connector that will allow for private listening.
The product must provide the ability to
interrupt, pause, and restart the audio at
anytime.
(f) When products deliver voice output in a
p
ublic area, incremental volume control shall
be provided with output amplification up to a
level of at least 65 dB. Where the ambient
noise level of the environment is above 45 dB,
a volume gain of at least 20 dB above the
ambient level shall be user selectable. A
function shall be provided to automatically
reset the volume to the default level after
every use.
Not applicable. There is no voice output.
(g) Color coding shall not be used as the only
means of conveying information, indicating an
action, prompting a response, or
distinguishing a visual element.
Supports.
Color coding is not used as
the only mean of conveying
information
(h) When a product permits a user to adjust
color and contrast settings, a range of color
selections capable of producing a variety of
contrast levels shall be provided.
Not applicable.
The product does not have
a function to adjust color
and contrast settings.
(i) Products shall be designed to avoid causing
the screen to flicker with a frequency greater
than 2 Hz and lower than 55 Hz. Not applicable.
(j) (1) Products which are freestanding, non-
p
ortable, and intended to be used in one
location and which have operable controls
shall comply with the following: The position
of any operable control shall be determined
with respect to a vertical plane, which is 48
inches in length, centered on the operable
control, and at the maximum protrusion of the
p
roduct within the 48 inch length on products
which are freestanding, non-portable, and
intended to be used in one location and which
have operable controls.
Not applicable.
(j)(2) Products which are freestanding, non-
p
ortable, and intended to be used in one
location and which have operable controls
shall comply with the following: Where any
operable control is 10 inches or less behind the
reference plane, the height shall be 54 inches
maximum and 15 inches minimum above the
floor.
Not applicable.
(j)(3) Products which are freestanding, non-
p
ortable, and intended to be used in one
location and which have operable controls Not applicable.
3

Version 2 DR-3080CII VPAT: Updated 09/21/2006
shall comply with the following: Where any
operable control is more than 10 inches and
not more than 24 inches behind the reference
p
lane, the height shall be 46 inches maximum
and 15 inches minimum above the floor.
(j)(4) Products which are freestanding, non-
p
ortable, and intended to be used in one
location and which have operable controls
shall comply with the following: Operable
controls shall not be more than 24 inches
behind the reference plane
Not applicable.
4

Version 2 DR-3080CII VPAT: Updated 09/21/2006
Section 1194.31 Functional Performance Criteria - Detail
Voluntary Product Accessibility Template
Criteria Supporting Features Remarks and explanations
(a) At least one mode of operation and
information retrieval that does not require user
vision shall be provided, or support for
Assistive Technology used by people who are
blind or visually impaired shall be provided.
Supports.
There is only a power
switch on the machine,
which is tactilely
discernible.
(b) At least one mode of operation and
information retrieval that does not require
visual acuity greater than 20/70 shall be
p
rovided in audio and enlarged print output
working together or independently, or support
for Assistive Technology used by people who
are visually impaired shall be provided.
Supports..
All operations are operable
with low vision and do not
require a visual acuity
greater than 20/70.
(c) At least one mode of operation and
information retrieval that does not require user
hearing shall be provided, or support for
Assistive Technology used by people who are
deaf or hard of hearing shall be provided
Supports. Visual information is also
provided on the PC.
(d) Where audio information is important for
the use of a product, at least one mode of
operation and information retrieval shall be
p
rovided in an enhanced auditory fashion, or
support for assistive hearing devices shall be
p
rovided.
Not applicable. Audio information is not
critical to use of this
product.
(e) At least one mode of operation and
information retrieval that does not require user
speech shall be provided, or support for
Assistive Technology used by people with
disabilities shall be provided.
Not applicable. Speech is not required for
use of this product.
(f) At least one mode of operation and
information retrieval that does not require fine
motor control or simultaneous actions and that
is operable with limited reach and strength
shall be provided.
Supports with exceptions.
Lower limb disability
(wheelchair):
The model is a desktop type
and the position of the
machine can be adjusted by
according to the height of a
desk.
Upper limb disability:
There are no operations
requiring fine motor control
or simultaneous actions.
5

Version 2 DR-3080CII VPAT: Updated 09/21/2006
Section 1194.41 Information, Documentation and Support
Criteria Supporting Features Remarks and explanations
Product support
documentation will be
provided upon request in
electronic format, at no
additional charge.
(a) Product support documentation available
to end-users is available in alternate formats
upon request, at no additional charge. Supports.
An evaluation of the
accessibility features of
products will be provided
upon request in electronic
format, at no additional
charge.
(b) End-users have access to a description of
the accessibility and compatibility features of
p
roducts in alternate formats and alternate
methods upon request, at no additional charge.
Supports with exception.
Canon U.S.A., Inc. provides
support services
accommodating users with
disabilities through
OKCANON assistance, TTY
support at [phone].
Canon otherwise available to
U.S. federal government
agencies through Federal
Relay.
c) Support services for products accommodate
the communication needs of end-users with
disabilities. Supports.
This document is for informational purposes only. This information is based on Canon’s current
understanding of 36 CFR Part 1194 Electronic and Information Technology Accessibility Standard and
Section 508 of the Rehabilitation Act. It is not intended to address applicability of these laws to a particular
end-user, customer, application or procurement.
All product design and specifications are subject to change. Some of the information may be based upon
data collected or tests conducted on similar product modules.
The information in this Voluntary Product Accessibility Template (VPAT) should not be considered a
contractual agreement by Canon. FURTHER, THE INFORMATION AND MATERIALS PROVIDED IN THIS
VPAT ARE “AS IS” WITHOUT WARRANTIES OF ANY KIND, INCLUDING WARRANTIES OF
MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR NON-INFRINGEMENT OF
INTELLECTUAL PROPERTY.
Canon does not warrant the accuracy and completeness of the information or materials in this VPAT. Canon
may make changes to the information in this VPAT, or to the products described in this VPAT at any time,
without notice.
6