CardioTech GT-300 User manual

GT-300 EKG Machine
QUICK START
GUIDE

GT-300 EKG Machine
Contact Us:
[email protected]
888-354-2968

01
Contents
Basic Setup
Powering on the CardioTech GT-300
Loading Paper Into the Printer
Connecting the Patient Cable
to the Electrocardiograph
02
02
03
04
FAQ
How to Fix Continuous Printing/Printout
Interpretations for the CardioTech GT-300
Leads are Connected but No
Readings are Being Displayed
06
06
06

02
Gently flip the CardioTech GT-300 upside down (screen
side down) to reveal the underside of the machine.
1.
Use the included screwdriver to unscrew the
battery compartment cover off. (Figure A)
2.
Insert the battery wire into the socket. Then, place the battery
in the compartment. Ensure that the white tab is at the top.
(Figure B)
3.
Replace the battery compartment cover, and revert
the machine back to its original position.
4.
Plug one end of the AC Power Cable into the power supply
socket, located towards the bottom left back side of the
GT-300. Plug the other end into an AC Wall Outlet.
5.
Powering on the CardioTech GT-300
Basic Setup
Figure A
Figure B

03
The GT-300 comes patient ready! The unit is now ready to use.7.
Ensure both lights in the upper right corner of the unit are on.
Press the power button on the keyboard to power the unit.
Wait until the parameters are present on the screen.
6.
• Top GREEN Light: The unit is being powered via AC power cable.
• Bottom GREEN Light: The battery is inserted and charging.
Loading Paper Into the Printer
Press the printer door latch (found on the left side of the unit)
downwards to remove the printer door.
1.
Remove the styrofoam place holder.2.
Before placing the paper into the printer, orient the paper
so that the black square is in the bottom left corner.
(Figure C)
3.
Lift the first page, & slide the paper into the printer. (Figure D)
4.
Figure C
Figure D

04
Connect the patient
cable to the patient
cable socket on the
right side of the main
unit, and then secure
them with two screws.
(Figure F)
1.
Connecting the Patient Cable
to the Electrocardiograph
After the paper is adjusted, tear the first page.
The printer is now ready to be used.
6.
Replace the printer door, with the first page of paper hanging
over the printer. Then, press the “Tab” key to properly align the
paper. (Figure E)
5.
*Back Side of Paper*
Figure E
Figure F

BASIC SETUP COMPLETE
Continue to Next Pages for
FAQ & Troubleshoot Issues
05

06
FAQ
How to Fix Continuous Printing/Printout Interpretations
1. Ensure the EKG is set up on ‘Auto’
2. If the GT-300 is not set on ‘Auto’:
> Press the “Mode” Soft Key at the bottom left of the keyboard
to cycle through modes until the configuration is set on ‘Auto’
3. Ensure the paper is loaded correctly.
Leads are Connected but No
Readings are Being Displayed
1. Readings will not be displayed if the following
are not set up properly or damaged:
> Leads are not properly placed on their corresponding limb
> Universal Clips are not connected, partially connected, or loose
> EKG unit, leads, and lead wires may be damaged

07
Scan here for additional
assistance setting up
your product

Providing Value
Without Sacrafice
5963 Olivas Park Drive
Suite F, Ventura
CA 93003
[email protected]
888-354-2968